Getting some h2o in the center floor locker areas, where the shower sump box is located, and the floor locker forward of that.. Over 2" deep... Pretty puzzled.. Any ideas ? Looks like left over from last fall, missed looking when she was put away.. Have wet Vac'd out, cleaned up with Clorox wet...
Had our beloved '96 Dancer for 7 yrs now. All of a sudden we are seeing some white, foamy like blooming substance under the stereo area in the horizontal seams of the different interior pieces. Approx.
1/2" dia., several areas. Doesn't seem to smell, wipes right up. Has stopped for now, but has...
I installed marine A/P's for 18 yrs.... mostly raytheon/raymarine... most likely you've got air in the lines from the helm pump to the hydraulic steering ram that did not get fully "bled" out after the installation. If your not comfortable with the procedure have a qualified marine tech do it...
We use "Roll Off" to clean the non skid on the 'Dancer, leaves a nice film that allows stuff to be fairly easily rinsed off.... Other than a shot gun.....
I did ALL the bow rails and cleats two seasons ago.. on our '96 330 Dancer... nuts and bolts all the way around.. I posted a full description about two yrs ago... have a GOOD friend assist you...used West Marine poly sealer an all bolts.. acetone to clean up the extra... note... original post...
That's it! Henderson products Deckadence! Anyone actually have experience with this stuff? Was soft on the feet, appears to be pretty tough.... Thx as always group!
While at the Miami Boat show recently, I saw a new type of Marine carpeting placed on the display 370 Sundancer.. I asked the Marine Max Rep what kind of carpet it was or who made it and He didn't know, said it had been placed there by someone? It was a kind of porous / fibre looking material...
Yes, that usually worked for me also..this "crap" was left over from winter storage, and has been giving me fits all summer... Starbrite deck cleaner did not remove the hardened deposits..
I suspect you may have a wiring issue, recently found a disconnect behind the dash of our '96 330 'Dancer was'nt mated all the way, caused the stbd. fuel gauge to go full scale empty..if you have the wiring diag's for your boat you can trace the wires from the gauges, perhaps to disconnects in...
I have tried numerous cleaners to lift dried spider doo doo off the 'Dancer, our harbor master said he tried Roll Off recently and was impressed.. So I bought a bottle and with a nylon bristle brush was able to finally clean the non skid of the the dreaded black spots :smt038 left a nice sheen...
I normally cruise at 3200/3300 rpm's, nets around 23.5/24 kts with 3/4 fuel, full H2O, 4 adults. Absolutely love this boat, third season. I would not want the smaller block engines on this boat, and the V Drives are the way to go for less seasonal mx. I/O's are easier to svc on this boat, but at...
I think you may have a bad relay.. I had the same Goode windlass on my '06 330 Dancer, replaced it with a Lewmar. On removing the Goode windlass, found a relay ass'y inside the anchor locker area. You may need to get a meter in there and see if one of the relay's contacts is inop.. I think the...