On a 76 that might be a challenge. Id take the screws out and cut the window out, clean it up and reinstall it with a quality caulk. I'm parting out a 1978 Express 30 ft. Sea Ray. Its not a fly bridge but some things may be the same. Let me know and good luck. John jpc2594@yahoo.com
If the motor is running and the drive doesn't respond then its the worm gear or gear bolted to the drive that lifts the outdrive. I had an electric shift with the same problem and it was the worm gear. Good luck
Hello, looking for some help. I have a 1981 srv310 that came with 454 330hp. I just bought another Sea Ray at auction with fresh 350's 255hp. The latter has strait drives and my 310 has vdrives. I need to know what ratio Vdrives I need to run if I repower from 454's to 350's:huh: Thanks, John
No windless or hatch supports. The rudders bolt on from the back of the transum, not through the bottom. The rudders and struts look in great shape. I'll check for numbers today.
The table is in great shape however the post has surface rust. The v drives are untested but look good. When the boat was run last there were no issues with them. The teak in the stern is weathered and i've found some small cracks. I guess it depends how bad yours are. I'll get some pics. I'm...
The hatches are not great but usable. If there for your 79 I think they are different. The 79 that I had used duel teak hatches in the middle with 2 engine hatched on either side. This has 1 large hatch with a teak insert. The horn looks aftermarket. Thanks, John
I have a 75 30' Sea ray Express that I'm parting out. Anything you can think of please ask. I'm trying to keep the 255hp small blocks complete (1900 hrs.) Walter v drives, windshield, bow and stern rails, interior ok and much more. Engines roll over but I haven't tried to start them. NE Ohio...
I have a 1975 30' Sea Ray that I'm parting out. Has both 255hp Mercruiser, Walter v-drives, shafts, props, windshield, front and rear rails, cockpit furniture, cabin furniture, cables, rudders, plenty of good teak and anything else thats on it. Engine hours show 1900. I don't know if they have...
Wondering if anyone knows if there is a rebuild kit you can buy for the windless anchor on a mid 80's Sea Ray. Its very common and on most 30' plus Sea Ray's in the 80's. Mine works well but leaks oil.
Does anybody have a line on custom design gas tanks for for older Sea Rays? I have a 1981 SR310 Sundancer and need a couple of odd shaped ones that go under the aft cabin. I found a company to build them for about 2 grand. I guess if I have to I'll bite the bullet I will but I keep thinking...
Looking for advice to change over from a macerator system to a pump out. I have a 1981 Sundancer 310 and it came with a flush toylet that holds untill full then with a flip of a switch it goes into a about a 10 gal. holding tank that when full macerates and pumps out. I guess you can do that in...
I'm looking for some cockpit seating and a front hatch for my project.:huh: Also need an alternator with brackets for a 454 bbc, flame arrestor and the cap that goes on the block at the bottom of the oil filter relocator. E mail jpc2594@yahoo.com or reply to this forum. Thanks
Thanks for the info Crispy! Looking forward to some pics on your Vangaurd Acnetcom. Do you have a aft cabin? Mine has no cusions and I'd like to know how they cut them up. One big one or several smaller ones.
I sold my 1979 300 Express to purchase a 1981 310 Sundancer with twin 454 V drives. I think its very similiar to the Vangaurd. My Sundancer has an aft cabin so there is alot more room than my Express that had strait drives. The archive was a big help cause there's not alot of these left to look...
Restoring a 1981 SRV 310 and looking for a cockpit seat. A 4 to 6 foot bench seat with the folding seats in the back that I've seen in many models of Sundancers with the cabin door on the port side will do. Need a veritone muffler and other stuff to. If you can help me email at...
Hello, how is the exterior furniture. I need a good double wide helm seat and a back bench. Does it have the Sundancer style doors to the cabin?? 2 piece fold up upper with a folding door below? I'm trying to restore a 1981 SRV310. Thanks, my email is jpc2594@yahoo.com