2007 Searay 320 Sundancer - Anyone install the EV-1 in the cabin's center bilge area? How the heck did you run wires from the helm to the cabin center bilge. I have fiber rods and fish snakes, difficult to find a path. And a solo task seems to be harder, i'm going to need my firstmate...
I like the idea of the center bilge for the EV-1. But trying to figure out how to run the wire has been difficult. I have fiberglass rods and fish snake. How did you do it? any help would be appreciated. Starting at the bilge, a simple hole into the shower sump area, and then it heads into a...
the 370 is nice. the 320 is smaller, i need to check to see if there is enough space in my gunwhale. Considering putting the pump there and the EV1 needs to be 3 ft away from the pump/magnetics/... Did you install the pump in the bilge, under the helm or somewhere else?
thx. yep the 2008 320 has a center larger bilge; pulling wires from there will be challenging. on the arc? thought the EV-1 needed a dry area? no? Do
I need a iTC-5? I installed new Transducers, sonar, and a 3-d touch Axiom Chartplotter last year. I just need to link the NEMA and...
No old Autopilot. New install. Center bilge next to shower sump? What path did u run the wires? Yep I installed the smarcraft and NEMA backbone to connect my engines to an axiom chart plotter. I have the seatalk- ng backbone to install the autopilot, and connect to the NEMA 2000 BB. Did u...
Anyone install a Raymarine Evolution Autopilot on a 2007 Sea Ray Sundancer? Where did you end up mounting the Ev-1? Im thinking about in the Cabin somewhere, where do wires route from the Helm to the Cabin?
4 other sea rats at this Marina had the same issue, cracked panel, they all did the FP solution $. Digital Marine Products is Plug and Play, better value. Chris is awesome ! Before and After pics attached. I’m King - Captain Z.
"You will most likely need to change out the TV power cord as the old power cord will not fit the input to your new TV. Power cord runs through bulkhead into a 110 volt power outlet which is located inside the 12 volt Main Distribution Panel. You must take the 12 volt panel cover off to access...
Any comments on the Vessel View Mobile (VVM)? good/bad
I installed VVM today on the Dock Holiday, 2008 320 Sundancer w/ twin 350 Mercs. It took longer to locate the engine harness switch, then it did to install behind the cockpit gauge panel, was lucky and had 1 open port out of a 4 way...
Thanks Kevin, I found a similar led with a on/off button so it doesn’t come on with cabin lights.
LED Dome Light, Niking Auto Universal Roll Bar Mount LED Interior Light Dome Light w/Switch Roll Cage Light Car Reading Light Courtesy Work Light for UTV ATV Polaris RZR Golf Cart...