Search results

I'm in the same situation. I did see notes that the vesselview 4 is for 2007 and up. I have a 2006 290DA searay, so I'm not 100% sure it would be true plug and play to replace my fading SC5000 unit. If you find anything out please post and I will do the same ....

Update: Replaced thermostat and noticed part of therm casket was blown out on original, that is water pressure pushed its way around the thermostat which explains lower water temps when idling. When engine warms up and is running , its about 170-174 degrees which is above 160 for thermostat but...

I replaced the thermostat since I think it was cooked after engine temp. went high due to impeller failure (most fins ripped off). Did not see impeller fins anywhere in thermostat housing after checking. However, I think I may have a faulty NEW thermostat (160 degree) because temp stays lower...

I just replaced my pump impeller after the engine over heated while idling out to bay. Since most of the fins on the impeller ripped off, I'm a bit concerned of bits getting stuck ... although idle test showed all is working well after change. I should have pulled my 290DA out of the water to...