:smt100
Looking for a dimension of the stern width down close to the keel. I have an opportunity to store my boat inside this winter. The cradle is 9 ft. at the base. Would this be wide enough?
Thanks in Advance
Ted
Thanks that makes one thing clear on my install of a Lawrance 525C. One other question what would be the best route for the cables from engine room to under dash?
Thanks in advance
Ted:smt100
Hey fellow 330 owners,
I will be installing a new GPS/fisher finder c/w temp sensor. Lawrance LMS-525C-DF.
Just wondering if someone can pass along any advice as to where the best place to route cables once I have them in engine room to under dash?
Also any suggestions as where I should...
I have a T12 Discharge and Macerator Pump and I question the Mac part. which is causing me some problems. I am lifed out for the season and have now discovered that my holding tank has not been empted as I thought it was:smt089. Indicators not working. T12 also seems not to be Pumping???? I...
Dennis,
When you say t pump do you mean T12 Discharge and Macerator Pump? I question the Mac part. I have a T12 which is causing me some problems. I am lifed out for the season and have now discovered that my holding tank has not been empted as I thought. Indicators now working. T12 also seems...
I had a simular situation last week with my 330. There is a port in the hatch, remove it and the hatch activator is about 12" to the port, there is a pin in the end of the activator remove the pin and you can lift the hatch manually.
Hope this helps
Ted
Hello from St. John's Nl,
Great to see as many Canadian SeaRay CSR members. We do most of my boating in Conception Bay and our home port is Hr. Grace.( 1 hour from St. John's) This will be our first season with our 330 so we plan on going further and venturing into Trinty Bay etc.:smt038
Ted
Tks Henry my 330 battery setup is there are two batteries under the rear facing seat that are for the port side one being a cranking and the other house. There are two more in ER one for starboard and the other for the gennie. I need new batteries as per my survey as I have just taken delivery...
Just installed new new batteries in the cockpit, main reason to open the eng. hatch, however with the switch on and showing 13 volts on the main panel meter I have no power to anything. What have I missed or what am I doing wrong?:smt100