I guess my concern was I did not want to cut off what would connect to the app on my phone. I want to be able to use the app on my phone and not have to keep up with remote.
To hardwire LED strips to fuse block do I just cut off the end Barrel connector or do I cut the wire in front of the controller? My main question is where do I cut the line to get the negative and positive that needs to be connected to my fuse box.
I want to install these led strips as deck lights on the same line as my courtesy lights. Should I buy a female barrel connector with bare wires and cut before or after the controller or just cut the barrel connector after the controller and rewire to fuse block?
I'm looking to wire
LED lights through out the boat
Striker 4 fish finder
Spotlight (2 side kickers)
Navigation lights including stern(will upgrade to led nav)
Stereo
Maybe live well
Will I need something heavier than
https://www.amazon.com/gp/aw/d/B000NV0BNM?psc=1&ref=ppx_pop_mob_b_asin_title
...
This is what's in my cart for project plus I have 16 Guage marine wire for led lights. I want to try to have everything I need for this project before I start.
I've been watching some videos and it really is straightforward. I'm going to start off with the fuse box and keep the switch panel. Maybe I'll draw a diagram to share. I'm hoping I can get it done before it gets too cold and I pull the boat out.
Any other input? I just brought the boat and I'm a new Captain. I understand basic wiring but not sure about those connectors. Wanted to clean it up and not just tap into a hot wire. I want a straight connection fron each switch line. Ild even appreciate a link for a deeper explanation. Would a...