Search results

Hello All Does anyone have information on hard tops available for the 400 sedan bridge. I have the ability to build my own but sure could use plans pictures etcetera to base a design on if I need to.

Hello All We took a cruise up the lake yesterday on the "Pour Excuse" 97 40' Sedan Bridge. I ran the engines up to 2800 rpms for 3-5 minutes and then continued back to sightseeing at 1400 rpms. A few minutes later the over-temp alarms went off. As we had never had an alarm go off it took a...

Hello All We have a 97 400 sedan bridge and the roller hardware on the sliding glass door is in need of replacement Does anyone know the name of the manufacturer of these doors or rollers?

Hello all We have a 97 400 sedan bridge. Under the mattress in the state room there are two shaped pieces of upholstered plywood . One covering the heat pump and one covering the batteries for the thruster. These two pieces of plywood do not cover the openings correctly and are telegraphing...

Hello All Our 1997 400 sedan bridge has 2 30 amp input receptacles. Currently this is supplied buy a single 30 amp cord with a splitter at the boat supplying 110 ac to both receptacles on the same phase. This puts a large load on the single 30 amp cord and connection often times these are warm...

Hello all I have a 97 40’ sedan bridge and am looking for the rub rail end cap that is above the swim platform on the corner where you hit stuff. I have located some that are 3” long but need the longer one at roughly 6” with mounting plastic studs around 2 1/2” apart. Any help with a vendor for...

Hello All On our 1997 40 sedan bridge,I have installed a new tv antenna on the radar arch. I thought running the coax to the tv pod on the rear starboard portion of the salon would be simple as there are access holes in the arch and the bridge. This seams to be wishful thinking as I cannot find...

Hello all We are wanting to replace the sacrifices on our 3116 cats and westerbeke 8 k generator. I am not able to locate magnesium or aluminum units for fresh water or part#s for the westerbeke generator. Does anyone have the part#s for the westerbeke genset or vendors for magnesium anodes

Hello all The fan is not operating the main head in my 97 400 sedan bridge and I have power to the switch. Has anyone replaced the motor or serviced this item. I’m not sure where it is located. Maybe in the top of the closet? Would like to get to it without tearing the boat apart. Thanks in advance

Hello all Just returned from my cold 1997 400da The boat is winterized but I leave the salon heaters set at 40 and use a bilge heater that is keeping the bilge at 40. When I arrived yesterday it was 24 in the cabin and both thermostats were blank displaying “- - - -“. When I opened the bilge...

Hello I’m new to my 97 400DB and we are very pleased with our new toy. I have been reading a lot about the balsa core construction that is in my vessel? Can someone help me with my HIN “SERP3750D797” What factory is “P” designating ? The boat is in very good condition but I’m sweating bullets...

Hello All I’m new to my 400DA and was investigating installing bypasses for the hot water heater when I noticed on the Atwood EHM11 that there were outlets for a heat exchanger that are not being used. I have twin 3116 cats and was wondering if anyone has plumbed these is in. Seems like I...

Hello All I have just purchased a sedan bridge I am concerned about remote monitoring the following -Temp in cabin -Temp in engine room -Shore power -Battery systems -Water Our marina supplies Wi-Fi and am wondering what is being used out there?