Search results

I have a set of heads for a Chevy 350 off a 260 merc. Heads are cleaned, tested. and in great shape. they're collecting dust in my garage. I have a new engine and these came off an old engine. Engine was trash but aparently somone had put new heads on it. Anyone interested?

:smt100The side window on my 268 need new gaskets . has anyone ever tried to get the windows out? taylor says they still produce the materials.:huh:

:smt100I found teac tambor door material. My 87 268 had all the cabinet doors damaged by water. I've gotten the old paper material off the doors. Could somebody suggest a marine adhesive that will glue the teac back to the doors with out destroying the teac?:smt021

:huh:I have found Teac to replace the trim on the doors and cabinets on my 87 268. What would anybody recommed for an adhesive to glue the new teac strips to the doors?:smt100

My 87 doesn't have a holding tank. It has a porti-poti. It has a macerator pump installed under the sink but it's not connected to any electrical power. Does anyone know how to connect the pump? Where should the switch be? I read a thread that a lockable switch was installed someplace? Where...

I'm going to put an A/C system on my 87 268da. Sea Ray plans show drillin a couple holes in the stringer in the aft of the eng. compartment. I think I saw a work in progress picture and tha area outside the stringer was filled with foam. Is that normally how they were built? :smt100

I bought my 268 off Ebay. I have the signed title from the seller. Florida is giving me fits because it was from florida, taken to Georgia, then back to Florida. They want it registered in every state. This is turning into a nighmare.:smt021

:smt038I have an 87 268. the porti potti in the head had a broken clamp that kept the top and bottom halves together. I found that dometic has the part and it fits perfectly. Comes in 2 colors. it's listed as a sealand latch kit. :smt100

I have an 87 268 with a 2 burner alchol/115 stove. What kind of fuel would anybody recommend for the alchol? I have coleman fuel would it work?:smt024

I used a west marine, Teac cleaner on some of the teac around the fold down table. I was amazed at what was under all that crud. That stuff really works:smt038

I have an 87 268da, I found that the top cap of the hull where it mates to the hull had seperated about midway down the hull. I had to cut the pop rivets that were in from the factory. I used 5200 and # 8x1 screws and screwed the top cap back to the hull. The clue that it had come apart was the...

I have an 87 268 with a 2 burner alchol/115 stove. Does anyone have a suggestion as to what fuel is ok to use? I have gallons of camp stove fuel, would it work?

I'm looking for a radar arch that might fit my 87 268DA.

I'm looking for a radar arch for a late 80's 268 sundancer. I know one from a 270 to a 290 will fit. Trying to restore an 87 268 and add an arch fir the radar Chuck West:smt021