Search results

Cant*

Let me know how it goes. I can source the ones for the engine but I’m curious to see how difficult they are to change

Loks like my engine ones do.. there’s no spring. It’s rotated. Both my engine exhausts are doing the same as well. The just spin around freely and I need to replace them

Some water heaters have the relief valve plumbed to the shower sump. If this is the case, you wouldn't see water around the heater. If the relief valve is going off then yes that would explain why the pump cycles every couple mins. look at the heater and see if there’s a hose on the relief...

I’m looking at the domestic CX110. Looks like a direct replacement. Anyone have one installed?

Here’s a link to the owners manual which shows a convertible dinette. If it’s not working, then perhaps a previous owner disabled it. Maybe it broke and they didn’t want to repair? screwed closed maybe?

It should slide out. Once the table is out of the way. The base is mounted on drawer slides basically. Not much different then what you’d have in your kitchen cabinets at home. Just heavier duty. I just grab the front of couch from underneath (at the front)and give it a pull

As far as I know, the convertible dinette was standard. I’d remove the cushions and look to see if the hardware is there.

I know, old thread. But my RSD115 fridge just packed it in. Curious if anyone ever found a comparable replacement? Thanks

I’d also like to know a fix? Both my weaco fridge and freezer don’t work when on dc. Great when plugged into 120 but nothing when on battery. New batteries too

That they are. But now there recommending I go with a 4 blade. Just waiting on pricing now. Hopefully not to bad

Soooo, after a lot of back and fourth with veems and their prop guru. Their now recommending a 4 blade 23x22. Vermstar LC.

I heard the same as well. It’s getting a little confusing to say the least. Was hoping to hear some first hand experience. so what will you end up going with when you change?

I’ve just been flirting with the veems prop calculator so far. It recommended the veemstar C which I don’t believe uses the strips. it also suggest going down to a 20” prop from 21 and an increase in pitch

Thanks for the reply. I’ve been hearing great things about the veems but not from anyone with first hand knowledge. I think I’ll pull the trigger and give them a shot

Ouch! Sorry to hear that. Veems recommended I go with a 20” prop which is down from my 21’s but a small increase in pitch. I’m just looking to increase my cruising speed a little without sacrificing my economy to much. I cruise around 3650 rpm @ 23 mph.

Curious to know how the veem prop upgrade went? I have a 2007 38 and I’m considering doing the same. Any input would help. Thx