Search results

  1. R

    Official 290 Sundancer Thread

    Thanks, let me know. I ended up using a hull through fitting that worked pretty good. I added a drain plug from my local hardware store. The only downside is that is a little raised so that the sink doesn't drain all the way.
  2. R

    2006 290 Sundancer amplifier location

    Does anyone know how to remove the speaker grills in the cockpit?
  3. R

    Official 290 Sundancer Thread

    Does anyone know where to get a replacement drain for the sink in the head? It's about 1 1/2" diameter at the sink. I was looking for stainless.
  4. R

    Official 290 Sundancer Thread

    So, I received mine. There is a slot at the top, and you just push the tab on the new key/button through it. The tab on the key has some flexibility to it. Make sure that there is no debris in the hole.
  5. R

    Official 290 Sundancer Thread

    I receive mine Wednesday, I’ll let you know what I find.
  6. R

    Official 290 Sundancer Thread

    What do you think about this? https://www.fpmarine.com/product-p/me-lockknob.htm
  7. R

    Official 290 Sundancer Thread

    I found the part number: 1776179 It is the complete latch.
  8. R

    Official 290 Sundancer Thread

    Thanks, I wonder what it’s called and where to get one?
  9. R

    Official 290 Sundancer Thread

    Next question. Here is a photo of the door to the head. How do you lock the door? Am I missing something?
  10. R

    Official 290 Sundancer Thread

    Here is the photo of the sink after my wife did some work on it. It is stainless steel and should come clean with the right products.
  11. R

    Official 290 Sundancer Thread

    My galley sink is looking pretty tarnished. What is it made of? Do they have replacements if I can’t clean it?
  12. R

    Official 290 Sundancer Thread

    It turns out that the back panel can move that much. I just needed to pull it back. I thought it would have been more solid.
  13. R

    Official 290 Sundancer Thread

    That’s a great idea! I’ll have to check. Thanks
  14. R

    Official 290 Sundancer Thread

    I connected to power at the breaker panel under the helm. It worked beautifully. To route the wires, I removed the ceiling panel in the aft berth. When I went to reinstall, there is a large gap at the end. It was hanging a little loose when I removed it. I'm thinking of adding a filler. Has...
  15. R

    Official 290 Sundancer Thread

    Here's some pics of the inst
  16. R

    Official 290 Sundancer Thread

    With my cars, I usually connect to the fuse panel.
  17. R

    Official 290 Sundancer Thread

    I’m well under way with the installation. I put it under the helm seat. What are my options for the power and ground connections?
  18. R

    Official 290 Sundancer Thread

    Thanks
  19. R

    Official 290 Sundancer Thread

    I could not find the right search words, what should I use?
  20. R

    Official 290 Sundancer Thread

    I’m getting ready to install a Heater Craft 4 port heat exchanger. I was wondering if anyone has done this and where did you locate the box. I was thinking of 3 places. 1: Under the helm seat which is empty. 2: Under the port seat. 3: Under the rear seat that is on the bilge cover. Thanks
Back
Top