I have a 1998 Sundancer 330 that I am about to replace the water heater on. Does anybody have any helpful tips or suggestions? Can it be done without removing any engine parts like the riser and manifold? Any help will be greatly appreciated..Thanks, GaryO
Thank you so much for getting back to me! I would like to go ahead and get the one for the port side of the boat if it is indeed like the one in my picture on my first post about this...my email is wydeglyde@hotmail.com...my mailing address is Gary Owen 139 Owen Road Rose Bud, AR...
just checking to see if anyone has bought these yet? I'm not interested in buying them but I sure would like to have a port side one made. Any help will be appreciated...Thanks, GaryO
Hello all.. ..I have a 1998 330 Sundancer I have a question about. The port side engine vent cover was damaged when I bought the boat. I have searched high and low for a replacement with no luck. Can I have one made somehow or does anyone know where I can find one to buy? Any help will be...
I’m not sure on the voltage drop and not at the boat now to check it.. I have switched the cable to the one on line 1 and it does the same no matter which cable it’s hooked to.. the cable for line 1 works with everything on that circuit being turned on at once .
1998 330 Sundancer... when I tried to use AC for the first time it trips the breaker switch... on shore power, when i turn the AC on, it shows to be pulling about 13 amps... as soon as the compressor kicks in. it trips the switch... I checked the screen on the water coming in.. it was clean and...
It is in a covered dock and has the cockpit cover on it when we are not using the boat...also, just had a month of no rain at all and still taking on water... thanks for the response though
Thanks for all the responses.. boat is in freshwater.. takes on water while sitting in the slip with nothing running..no a/c, no water system, no toilet, no water heater, etc... must be shaft seals or rudders I'm guessing... on the bilge pumps... the one to the far rear is hooked to switch...
Recently purchased 1998 330 sundancer.. first boat with twin v drives..I’m getting a few gallons of water in my bilge each week.. should I be concerned? Thanks
turned freshwater pump on yesterday and closed all faucets but pump continued running.. pretty soon bilge pump started pumping water out. have water at all faucets except bathroom, so I'm guessing I have a broken water line to bathroom faucet. any suggestions as to how to find and repair that...