Search results

  1. Nagaj54

    Engines shut down

    I have a 38’ Sundancer with 8.1 HO’s. Both engines at same time shut down. I will get a system beep and both will shut down. No codes will come up. It is at Random times but mostly just after start up. Most times all gauges shut down and engines stay running. Only few times engines shut down as...
  2. Nagaj54

    38’ DA Main Cabin sliding screen latch

    I am looking to replace a broken sliding screen latch in the main cabin. Can anyone tell me a part # of this part?
  3. Nagaj54

    Engine Shutdown

    These are 8.1 HO engines with about 700 hours. They have been in salt water for about 2 years only.
  4. Nagaj54

    Engine Shutdown

    I have a 2006 38' Sundancer, both engines shutdown running at about 2000 RPM's. I have heard a beep and have seen both engine gauges drop but never have had the engines both just shutdown underway? Any ideas? Ground fault but both engines do this at same time. First time shutting down on me. But...
  5. Nagaj54

    8.1 Bogging at high RPM

    I just had the injectors done and fuel pressure regulator. Merc Cruiser had a recall on my year 8.1. I took boat out after and did not notice first run because i did not go over 3200 RPM. The next time i used i went WOT and thats when I noticed the fluctuating RPM at 3600 to 4000 RPM. I did not...
  6. Nagaj54

    8.1 Bogging at high RPM

    I have a 2006 Sundancer 38’. 8.1 HO engines just had injectors cleaned. When I hit about 3600 to 4000 RPM The port engine RPM drops to 3000 then back up then drops to 3000 then back up? Any ideas what would cause this pulsating RPM
  7. Nagaj54

    38' Sundancer sliding door

    I have a 2006 38' Sundancer. The main bedroom sliding door is off the track. Can someone explain the best way to get it back on track?
  8. Nagaj54

    Hydraulic Power Steering

    I lost power steering this weekend. I have the hydraulic cap at the helm behind steering wheel. Heading out the rudder was at 27 degree's when turning the wheel it did not show it was moving on the gage. It is a 2006 38' Sundancer. Thinking it might be low fluid but its a closed system so not...
  9. Nagaj54

    Engine compartment Paint

    I am looking to paint my 2006 38’ Sundancer’s engine compartment and a few other compartments that have chipped paint. Any suggestions on what I should use ? I want to match colors as close as possible and want something to adhere well.
  10. Nagaj54

    Fuel tank level sender

    MY 2006 - 38' Sundancer Starboard anolog fuel gage stopped working. Is this a grounding isuue or do I need a new float sending unit? The electronic gages work and show how much fuel I have. New to me boat so I am new to this.
  11. Nagaj54

    8.1 Mercruiser Problems

    ok, the boat after injectors were cleaned today ran Amazing. 2500 RPM to over 4500 and humming like a bird. So, I am learning so much about these 8.1 HO motors. The injectors were so badly clogged they were causing much more noise and vibration. Also noise from the V drives it sounded like...
  12. Nagaj54

    Fuel Injector

    Yes, all cylinders 170 and 175. Thanks for correction on PSI, this is all new to me.
  13. Nagaj54

    Fuel Injector

    So my flow test reads: 45 PSI static flow test - LB/HR at 45 PSI - all Injectors are between 37.7 and 38.5 PSI Is this an acceptable flow rate? Before cleaning they were at 7.0, 20.0, 18, 19, 37, 37.5, 37.2, 37.4.
  14. Nagaj54

    Fuel Injector

    What should the PSI be at the fuel injectors on an 8.1 HO 496 MAG? I just sent out the injectors and 4 were not spraying good. Had them cleaned and was told 36 PSI is what they are pushing? 1 was only spraying 7.
  15. Nagaj54

    8.1 Mercruiser Problems

    I am having issue with starboard engine. Started this season at max 3400RPM Now it maxed at 2500 RPM Did plugs and test wires. Fuel rail reads 40 Psi even under load. Can only be injectors now? Correct?
  16. Nagaj54

    8.1 HO FUEL ISSUE

    Lol, how could I miss that. Thanks so much, I see it now...
  17. Nagaj54

    8.1 HO FUEL ISSUE

    Does the 8.1 HO 496 MAG have a fuel pressure regulator? If so where is it located? I see on the fuel rail there is a dampner but do not see a regulator.
  18. Nagaj54

    Shower Faucet leak... is this fixable or a replace

    I did pull the knob off and have access to the valve stem. The stem turns but I cant seem to figure how the turning stem comes off to get access to the O-Ring?
  19. Nagaj54

    Shower Leak

    Anyone know how to change the valve O-Ring on detail #6. I cant seem to figure out how the stem comes off or is it need full valve replacement ?
  20. Nagaj54

    Shower Faucet leak... is this fixable or a replace

    Can anyone tell me how to change O-Ring in detail #6. Wand keeps leaking when pump is on.
Back
Top