Search results

This may be nitpicking but can you adjust the wheel so that when you are steering "straight" the SeaRay logo on the wheel is horizontally level? Thx.

have 04 260. there is a rubber cover that goes over the key hole of the starter. where you put the key in. has anyone had to replace this as mine is falling apart?

Have 04 260. Want to replace panel on refridgerator from wood grain look (believe OEM) with something else. Maybe stainless or black. Anyone done this or give some advice?

I have the smartcraft on my tach. For a while now the depth alarm goes off fairly frequently no matter the actual depth! it is through hull original install. the alarm signal will go off then continue to show "depth alarm" for various periods of time, then go back to normal soundings. I've...

Thinking seriously about replacing my bulbs with led's. Have researched alot. Does anyone have experience with superbrightleds.com? Share please good and bad, if any. Prices seem to be below other available suppliers.

Have a "dome" light above stove in galley. Has 2 bulbs, one for ac and another for dc. Want to replace with leds. Has anyone ever done this, which bulbs and the manufacturer or website used? Thx.

Went to boat to check on everything, found heat not working. Fan working, temp setting at 68. Control shows on heat, but shows "heating" for only about 10 seconds, then shuts off and after 5 minutes, repeats the process. Switched to gen operation, no difference. Any thoughts guys?

Has anyone ever installed rod holders on the 260? Starboard and port sides. Port would be just ahead of the battery switch box and starboard ahead of the storage locker there. I'm concerned as to what is underneath before I drill those holes? I can't get a good look in both those places. Advice...