Search results

NAPA best belt and price .

i have a leak where the pipe from the air filter connects to the turbo

And also i cleaned and checked the oil return valve.

Hello everyone, I need your help and opinion guys. I have 3126 and it has AirSep after some time of work I have a small oil leak between the air inlet and the turbine. I've removed and cleaned the whole AirSep system, doesn't help.

I did this job, Virginia diesel did long block for me.

I owned a 330 EC with 340 Hp Mercruiser and it was underpowered for me, 370 EC is a heavy 40 feet boat, spend more money get a diesel, It's like day and night, my personal advice.

My screws were bad had to be drilled and new ones made.

Yesterday I changed the Gutless bearing.The key is to have the right tool.

Thanks, I understood now . I meant a different technique, here is a mixture of foam and epoxy.

Thank you, can I have some details if the foam came out through 1/4 hole , where did you pour the epoxy resin?

i thinks it could only work if there is absolutely no moisture in the panel . If there is moisture the epoxy will never get to all the voids or stick.

Oh yeah thanks my mistake thanks .:)

Thank you, I think I have a weak platform, it needs to be reinforced.

Hi all . Are there any ideas to put a 370 jet ski 700 lb on the swimming platform.

Just change new injectors and make all adjustment , also send Fuel compressor to CAT for overhould and get another 2000 hours

I like this hull better than the Cabo, in good condition this boat should be priced like a Сabo. My water tank is leaking long time , previous owner don't take care be a lot of work with fiberglass reisin .

Welcome on board David. I had a 330 EC, this year I bought a 370 and dud a lot of work on boat , changed the starboard engine....... In August I start move from Panama City FL to NJ. I got into the bay near Tampa at the epicenter of a big storm, the wave was about 16 ft. the wind was very...

Hi All . Does anyone have this tool, StrutPro or the like who would be willing to lend or rent? I have my boat is NJ and am looking to change my cutlass bearing on my Sea Ray 370 EC myself. Shaft diameter 1 7/8 Thanks!

Does anyone have this tool, StrutPro or the like who would be willing to lend or rent? I have my boat is NJ and am looking to change my cutlass bearing on my Sea Ray 370 EC myself. Shaft diameter 1 7/8 Thanks!

Just made the transition from Pensacola FL to Toms River NJ over 2000 mile . We were hit by a storm near Tampa and the wind was about 55 knots. I have seen depths from 15 to 27 ft on the fishfinder. The boat is incredible. A lot of stories .