I am keenly interested in this thread. I have just ordered the parts to replace the impeller and anode on my genny, will look for the cables when I do it.
My 2007 300DA has the Smartcraft gauges, not the vesselview screen. I am using a YachtDevices YDEG04 to send data to my Axiom 9+.
I will...
I am very interested in performing this upgrade on my 2007 300DA.
Was it necessary to recalibrate the Smartcraft gauges afterwards? What was the wiring installation like?
Thanks for posting this
I will be replacing the throttle cables as well, but aren't the original cables Gen II already?
Any pics you can share of your installation would be appreciated. I am starting my research this week for a spring installation.
Thanks, I have seen that. The output hose from the pump can be oriented in different ways, my issue is specific to how the tank is installed in the 300. Until the boat comes out of storage I can't inspect myself to figure it out, wondered if someone had experience.
Anyone done this on a 2002-2007 Sundancer 300?
I can't get to the boat just yet but planning the job using photos I took... It's not clear to me how to access the duckbills between the holding tank and the pump. Is it necessary to unbolt the accumulator from the bilge floor? Is it easier doing...
I am having issue with my 2007 300DA. Right shifter is stiff and the neutral detent is so vague I am never sure if I am in gear until I add some throttle. Left shifter is marginally better. Makes docking more challenging than it should be!
I had the mechanic replace the shift cables, some...
I have a 2007 300DA and my shifters are well aft of centre when the neutral detent is met.
I believe it is a Commander 4500 GenII unit, shift cables replaced this year with genuine Quicksilver parts.
I would love to get the alignment fixed... assuming it is similar to yours, do you loosen the...
Thank you!
I suspected as much, now planning on a new Axiom+ 9 in the spring. Your picture helped me visualize it.
I have the smartcraft gauges so will be keeping them in the upper binnacle but tying them into the nmea 2000 network later.
New to the forum here... just purchased my first Sea Ray, a 2007 300DA.
Already looking ahead to possible upgrades and tweaks. Current chartplotter is a Raymarine C70 with the known intermittent screen issue. I have removed the unit and will attempt a repair, but thinking ahead to a new Axiom 9...