Search results

do you still have 17x17 rh and left 1.25 shaft. wick

there is a small cutch pack that keeps pressure on the out drive . this keeps it from comming up when you go in reverse. but you said you have troube finding reverse. this sounds ike a cable out of adjustment. i will look in the book tomorow on how to adjust cable . its easy and a good place to...

having had one of these outdrives i became really familir with them . what you have is a hydro-mechanil shift. firs thing i would do is pop the cover off the shift control box it should be right behind the engine and ck the cables. ck the fluids to make sure there is no water in the lower unit...

the shafts are 58 long single taper and the props shouldbe16x16 with a slight cup. i found shafts at a decent price but the quote i recived for the props seemed really high to me.

:smt021when i bought my project boat it was missing props and shafts . anybody have any hanging aroud?? i thought it wasnt a big deal until i went to buy them . big money . would like to find some used ones if i can . :huh: thanks

some pick would be great. thanks

when you hear the click and it doesent move . hold the switch down and ck to see if you have power at the tilt motor. you could try a switch they are cheap and easy to install. i would ck the selinoid. there are two for the tilt. you also have two for the trim and one for the starter. it...

sorry i should have stated i have twin inboards. the exhaust comes out the rear under water on the port and starbord side. i'ts an odd set up that i have never seen before. by the way did you get your steering to go straight????

that,s what i was thinging. i think the in-line set was an after thought when they designed this boat. i have the folks at centek on speed dial. they are making the crossover tubes that come off the risers. i have used them in the past and they do great custom work.

do you have any picks of this vent. ? what keeps water from comming back up the pipe. the exhaust i took off was rotten all the way up to the risers.. have you had any problems with the box leaking.?

anyone know how the exhaust came from the factory on this boat. mufflers.????????????:huh:

there are no flappers where the exahust exits. i am trying to find how it was done from the factory. the mufflers i had have a weird offset not straight through.

i dont really wat a loud boat anymore. did that for years. not that i dont like things loud . i just want this one quiet.

cant seem to get all the picks at one time

some more pics

i forgot to load them with post. the exhaust is below the waterline but no lift nufflers?? dont understand

i need help trying to figure out who the exhaust is supposed to be set up on my 77 30 ft sea ray hardtop. the mufflers i took off were rotten and not made anymore . i dont understand how the exhaust box works. any answers or help would be great:smt021

i bought the pait from a co in nj . they said it would work fine . just wondered if anyone has used it a marine application. i know the whole thing should be black but i like a little color. not sure about sig??

canter rise will breath better. but dont go with the cheap ones. i did that 2 years ago they lasted on season befor cracking on the out side . thought i would save myself some money . it didnt work . had to but new ones. there are so many places to get them from . try to get them locally so if...

i should have read this sooner . i have on at my shop. sorry .