Search results

Yes it’s alpha one gen two it’s the port drive it looks like the upper housing goes from 11 for forward 10 for neutral and 9 for rev at one point I got it on and was able to shift from forward to neutral and then rev but I had to get it to about 3/4 throttle in rev for it to engage in rev so I...

Why can’t I get my lower unit back to shifting properly after I removed it in neutral (I know I made and opsie it should have been in forward but it wasn’t)

Good evening I removed my lower unit in neutral and now cannot get it to shift help please!!

That might be a true statement but it’s a 27 gal tank and I’m sure it wouldn’t overflow after the hose being in the fill for 1 or 2 minutes

Hey all my pump won’t shut off and I can’t build pressure the only time it works is when I have a hose running wide open in the tank fill I guess the pressure from the hose primes it I would like to replace the pump any suggestions on what gpm I should get the current one when it decides to work...

Hey all my pump won’t shut off and I can’t build pressure the only time it works is when I have a hose running wide open in the tank fill I guess the pressure from the hose primes it I would like to replace the pump any suggestions on what gpm I should get the current one when it decides to work...

Hey Jim I have an 06 280 dancer where did you get the custom sheets for v berth? Thanks

Thanks yest I ordered the pad but go figure when I opened the boat today with all heat and sun everything works normally! It might have got wet with rain and now dried out I’m still going to get all the parts in case it happens again

Can you send me link please

My port keypad went haywire! The blower turns on by itself, the acc buttons light up by themselves,and the trim tabs don’t work. Yesterday when I turned on the batteries all three lights came on then shut off after a couple minutes. I hit the blower button and heard a pop below helm then it all...

Fwd

Fwd

Yes that’s how mine is I believe it’s supposed to work like that

I’m having similar issues when I turn on batteries my port keypad lights up then shuts off then blower turns on by itself then if I press trim tab aft acc lights up then fed acc turns blower on etc etc yesterday I pressed blower and heard pop in the fwd rim under helm then all switches where...

I’m having similar issues when I turn on batteries my port keypad lights up then shuts off then blower turns on by itself then if I press trim tab aft acc lights up then fed acc turns blower on etc etc yesterday I pressed blower and heard pop in the fwd rim under helm then all switches where...

Thanks

Would happen to know what model the the throttle controls are? Commander or something else on an 06 280 dancer

Thanks for your help I appreciate it and yes I will be mindful of that the v8s do like a little up trim but your right the hull doesn’t need much up trim

I hear you it just doesn’t make sense the gauge never worked but the trim did now the still doesn’t work and the trim only goes down is it ok to se trailer switch to go up while underway and throttle switch to go down being that I’m in the water I can’t get to pucks

Trim gauge did not read old equipment but it worked when new stuf installed it worked when I tested it a few times on one side then stopped (port) starboard side did not work at all they were installed by two different people (same mistake twice) the gauge still does not read up or down which is...