Search results

Hey, just a heads up, boat still purring like a champ!! I have a question concerning all my biat guages....My guage lights barely light up. When I messed with my ground wire it seemed to help a little better. What connector do I need to buy that slides over the THREADED pole on the back of the...

Thank you! Will definitely get these! It's affecting my exhaust and trim and who knows what else...lol

So after all, it was the fuel injectors. Had the boat out in 90° weather and not a hiccup!!! If u guys hear of the same issue, start with the injectors if they have them. Thanks a lot guys, u were a big help in all this, so, " thank you"!!

Can u send me a link, I'm pulling up a bunch of stuff off that... never mind found him finally...$80. After test run when injectors come back, I'll send this off next if still acts up...really leaning towards that vapor locking....might order a fuel pump assist and try that, reading tons of...

LOL....I hear ya!! But if u have one laying around, send it to me to try out!!! LOL

No, I don't have another one...

I haven't had anything tested or scanned yet... no one around me does it, I have to take my boat 1.5 hours away to get it done. Throttle not sticking...throttle control sensor, I'm going to order next week, I should have put that in when I put the IAC in...lol.

Well went ahead and replaced the IAC and not even the slightest improvement...ugh... I guess I'll take the plenum off and take the fuel Injectors out and send them off to get cleaned...it was horrible hot out today and as soon as I started it, she purred like a cat. I shut it off for about 4-5...

10-4....just what I needed! Tks! .....again..lol

Yes, each one has a pin that doesn't work. They are hooked up to control my exhaust. I just need to replace both. Trying to find a similar match since I can't find this same exact one. I just didn't want to get something under/over power, if that's possible..

I added another pic that u can see the numbers on. I can't find this relay anywhere at all using the numbers on it. What relay could I switch these with? I have 2. Just curious on the amp and rating can I use? Example... can I use a 12VDC 40 Amp fuse in its place? What the safest and strongest...

What are the breakers called that mount on the back wall and control the Exhaust Solenoids? I can't find any but the one on the right that's a push button CDM 10Amp... [] []

Yeah, I think that's the smart approach. I just ordered the IAC. Should be here Tues. or Wed... I really hope that's all it is. I remember the Boat shop saying that it was something and it was going to cost $1500 for just one part...I hope whatever that is....I don't run into that cost....

One last (HOPEFULLY) question, do I have to drain all the water in my engine to take of the plenum and then injectors?

Holy s!$! that's some payday! What about sending them to get cleaned? Also, how do I get to them? Is it pretty straight forward or real technical?

Yes, it will run great, it seems as though when it heats up that all the issues start. I even put in another blower, one coming in and one out to circulate the air. And yes, restarting in the MAIN issue. It will run fine, then when I shut it off and try to restart it just turns over and over...

LoL.... I'm looking at all this way to long...

Uh oh.....Injectors? Well I'll start with the IAC then see how she runs... Anyone have a link to a manual for this motor??? Really could use one!

I went under Sterndrive, Gas, 7.4L, 7.4LX MPI GEN V, 1996-1997 0F802000-0K999999 Would it be part 33 on the screen shot I sent u? Part # 805224A1

Anyone have a service manual they can send me?