I have an 1 1/2 inch chunk missing from my 2 inch pin striping from side of hull. On picture it is under the area by the yearly sticker and sorry you'll have to zoom in. It's the only picture I could find. Is it possible to find something close that I can just splice in? Recommendations where to...
Thanks smcnally11
I only got:
New metal plate that impeller rests on
New metal gasket (in question)
New fiber gasket that has bead of silicone around center of gasket.
Looks like they want me to put bare metal plate under the main plate. Found a thread on this forum that member installed it as...
I just bought a alpha1 gen2 impeller kit and it now comes with a metal gasket that goes under the plate that the impeller spins on. My old one had a rubber gasket and the directions say that it has been changed to the metal type. Doesn't make sense to me. So I bought a rubber gasket too. My...
My nephew just bought a 72 22 foot searay and I want him to replace the impeller in the outdrive because he has no idea how old it is. It's a small block v8 and he was told it was a pre alpha outdrive. Not sure if that's the correct term. At any rate could someone help me with a part # or a link...
I will have to ask more questions as I get started. I'm good at mechanical stuff as I have several classic cars but glass work I have never done. I did watch most of the youtube videos on that 1995 220 SeaRay, that guy did an great job in my book. I'm 64 so I know I'm not going to be able to do...
I have a 92 220BR "original owner" and the floor area next to the engine is a little soft and the floor section that covers my fuel tank when I removed it is also looking tired. Boat has been kept out of the direct weather for most of its life. Kind of surprised the stringers are getting soft in...