Found the smaller size roller toward the windlass but have not been able to find on any web site the lower one. Measurements are: 3" wide, 4-3/4" diameter and a bore hole size of 3/4". Need both the roller and insert (stainless steel). Anyone know where to find? Thanks, Bill
This is the inner door and has no rollers to adjust. I am able to slide back and forth on bottom plate but can't clear the "stop" under the door that's located about the center point where the two doors meet. Outer door is no issue and lowered the rollers and able to lift off easily....the...
No picture can be taken as it is under the "stationary door" that I can slide back and forth but can't lift the door over this stop. Has anyone removed the stationary door and if so, how were you able to clear this obstacle to replace screen door? Thanks, Bill
Yes, lowered these all the way down and how I was able to remove easily, the outer door. The inner door has a "stop" that prevents the same that I'm trying to figure out how to remove as I can slide the door back and forth but can't clear the stop under, what is normally, the stationary door...
I found the same "stop" located under the "stationary door" but couldn't remove it to pull the door out. How did you remove this stop that sounds the same as what I'm dealing with? Many thanks!!
Am needing to replace my screen door and removed the outer door with ease but the inner door won't clear an obstacle under it. Am able to pivot the door left and right but not high enough to clear the track and there is something under the door preventing me from removing. Has anyone removed...
They have been very responsive thus far with quote, details, etc. I've heard from them multiple times but haven't pulled the trigger just yet. Thanks!!
Thanks, had nothing but issues with the installation on my last one from SeaLift. The lift was fine but had to rush my 420 back to dry dock as bolts not caulked properly and vessel was taking on water. I've taken them off my list unless they have a different company doing the installation...
Does anyone have a recommendation of a reputable hydraulic swim platform with pop-up chalks for a 2007 Sea Ray 44 Sedan Bridge that will hold either a jet ski or tender. Have used one firm out of FL before with a very poor experience.
Someone before me replaced the carpet with artificial wood flooring. In doing so, they replaced all of the floor hatches with thicker wood due to the fit. Does anyone know the original thickness of the hatches (without carpet) as I want to go back to the original based upon the poor...
Mine is a 7.3KW GAS KOHLER 120V/60. All switches on at the electrical box in the bilge are on. I have replacement switches for the salon on their way but I'm guessing. Since I have a light in the salon for the generator solenoid but right next to it is the pre-heat/on switch and all of the...
Went to start the gen-set and when I flipped the switch in the salon, the solenoid switch light came on but then I went to turn on the next switch, the pre-heat /on, it did not light so I still tried to start and nothing...won't crank over. I went into the bilge and checked the circuit breaker...
Many thanks! After hunting more in the bilge area, there are two large black covers, one for the breaker panel and one come to find out covers the module and several solenoids. I took a new coax cable and went directly from the module to the system monitor at the helm and no change. In...