Search results

I’ll be going down to my boat this weekend. I will grab it. Check it out. Take a picture and send it.

I have that insert you’re looking for

Looks like it might be good for parts

Deisel i believe 1 3/4

No, I didn’t get the measurements on that table yet. If it’s not any trouble, I definitely would like to have something made before spring. Thank you

My boat runs on120v

Hi I have a 400 db same engine i bought this boat with 450hrs had the wheels turned down too 22.5 no problems it will cruise @23 mph at 2100

I had the same issue what I did to prove the regulator failure theory I backfead the city water from the dock into the faucet adjacent to the pressure regulator that faucet freshwater washdown, bypasses the regulator it will determine if it is bad or not

Hi can anyone give me the measurements on the bridge stock table looking to replace it with a new one my boat all wrapped up thank you and happy new year

Mine did only use it come spring to power up my charger I hope it works again this year

You can buy 50amp female to 120volt male Amazon 25 bucks

Change the key switch it could be your answer

That’s fast, i don’t get that speed unless im throdled up i have Cummins in my boat and my wife has it loaded up its heavy

I had my props turned down to 22.5 and i am getting 24 mph @ 2200 rpm so i would think they may have been altered

Pontoon boat seats.com

Sorry I sold them back in May

Thanks i appreciate the feedback looks like a pretty straight forward job my thoughts were to send the shaft to the shop check it for balance and change cutless bearing before reinstalling it

Hi have a dripping dripless seal I’m looking to replace,i want to remove the shaft and replace the entire assembly can anyone tell me what size socket needed to remove the nylon nut behind the coupler that attaches the shaft,thanks in advance

If this makes things any easier I cut an access hole over my starboard alternator under the soffa it made changing that alternator a piece of cake when I was through. I made a access cover for the hole I had made for future repairs. It made it easy to reach my zinc on my heat exchanger as well.

I own two of them a 310 and a 460 sport both hypolon and aluminum hull great boats