There was a short in the wiring connector near the cool fuel 3 module. it was not the connector to the fuel pump itself, it was the connector that goes to the fuel control valve mounted to the Port fuel tank. I replaced the valve but there was no improvement. In chasing the wires I found the...
I am having an issue with my e-plex clock in the galley and the touchpad in the head on my 36 sedan bridge. Both panels make a faint humming sound when on. All systems are working. No error messages. Nautimart ran the clock on the test bench and it checked out. Seems like a bad ground or...
Here is a photo of the terminal block the wiring to the underwater lights is connected to (in pairs). The power (bottom row) is connected to the N12 Module. I purchased a new 4 rocker switch from Nauti-tech in Fla a month ago for $650. I replaced the transom switch but I believe it is...
They were on the boat when I bought it but the wiring did not look factory. looks like 14 gauge red/black in a white casing to each light. They were wired in pairs and run to a 4 pin bus then to a module on the transom. I will get the module number for you later today and some pics.
They are expensive but well worth the money IMO. They scroll though the color spectrum rapidly when turned on then more slowly. A quick on off at the transom or bridge switch will maintain that color. They do eat power so best on shore power or genset. 20 amps for 4 lights.
The Hull rocker switch does not dim the underwater lights but it does permit you select a color by turning it off and then back on again as the lights scroll through the color spectrum. Just bought and installed a new 4 gang eplex switch on the transom yesterday as mine was corroded like most...
Hello Poggy, I purchased a 36 DB last year and the blackwater gauge behaves exactly as you describe but the fresh water tank reading is in increments of 1%. Not sure if this is design or defect??? Hopefully someone here will enlighten us.
Espos4. I do have the cool fuel 3 modules. Sea ray tells me they were both replaced. Thanks for the reply!
LG111. Great info thanks. I will swap the CPS as you suggest when she goes back in the water next month and let u know the results. Much appreciated
I am having the same issue with a 2007 36 sedan bridge w/496s and DTS. Starts and idles great for 5-10 minutes then stalls and wont restart for 15-20 minutes. How did you folks resolve this issue???