Search results

Looking for a mercruiser quicksilver top and bottom binnicle cover for duel throttle please Postage to qld Australia

Looking for a mercruiser quicksilver top and bottom binnicle cover for duel throttle please Postage to qld Australia

Looking for a mercruiser quicksilver top and bottom binnicle for duel throttle please if anyone has one laying around. Can get away with just the lower part if need be. Postage to qld Australia

Any painters here that can tell me what grade sandpaper I need to use to prepare the hull for 2 pac primer and what do I use on the top side over the non slip. Tia

Thanks we think we found them but I believe someone at some point has tried to bypass this as from what I see the head goes directly into the tank

It seems I may be getting back flow into the head. Originally the water would always turn black in the pan then after cleaning and sterilising the holding tank we had some blue water in the pan. I hear a lot of talk saying you must change the duck Bill valves but I can't for the life of me...

Sent email mike

Yes if I turn squelch I get a noise, no clicking when I press the mic, no radio check from local station

Not sure if this is an electrical post, my apologies if not, My vhf turns on and scrolls through the channels but zero sound. I checked the aerial and it seems ok. Is there a way of determining which is at fault, radio or aerial rather than having to purchase both. Tia

Yep I did all this painful job

No I'm dealing with that at the moment, were using 50/50 bleach will post pics

We did a full refit

For those with that horrible big blue or maroon helm here's some easy updates. Hatch replaced with 10mm smoke perspex used existing hinges $150 material Helm covered in white vinyl approx $140 material glued straight on Switches, new perspex cut, covered in wood wrap, new switch banks added...

OK almost done but I have somehow messed up the bilge lights, there are a couple of blue wires laying around I think number 5 and 25.. But putting power to them is doing nothing. It's really tight behind the dash. Does anyone know which wires are for the bilge lighting (deck on my boat) Other...

I left the fuses attached sitting underneath the dash, access underneath, I just wrote on each block what it was used fir

Almost done just the dials now took a couple of hours

First 2 done now the other 12

The switches I sent a link to are the style, we purchased from a local boat shop. I suppose I'm looking for someone that can tell me which wire I take from the toggle switch and put on the new switch

Thanks for the answers so far, here are the type of rockers we purchased this was due to lack of depth in the panel,. So I guess I need to keep the existing fuses, which I can probably mount into a small panel and mark them up behind the dash, is it then just a matter of taking the power lead...

No I heard from someone else to try 50/50 bleach as it worked for him. I did a test panel it was fantastic. Im going to do this first