Search results

  1. Steven Sanchez

    Official 320 Dancer Thread

    Looking for help - Transom Door Bushing is missing on my 2003 320 Does anyone know where I can get a replacement for this - it is the bushing in the hole for the transom door in my 2003 320. It is missing and door rattles a lot and is starting to chip gelcoat around hole. It is listed in the...
  2. Steven Sanchez

    Official 320 Dancer Thread

    I just went through this - it took me about 3months and about 100 contacts to get this right - if you want you can PM me and I am happy to help but suffice it to say here is what you need to do it Part numbers 2ea 84-879981T20 - 20 ft. (6.1 meter) SmartCraft data harness non DTS with (1)...
  3. Steven Sanchez

    Official 320 Dancer Thread

    Help on Lofrans Progress 1 Windlass I have a 2003 320 Dancer with a Lofrans Progress 1 Windlass - which is a real challenge to say the least - the finger is giving me fits - I have that handled but I need to replace the RODE - I have read 1/2"(14mm) Rope and 8mm 5/16" Chain and I have read 5/8"...
  4. Steven Sanchez

    Official 320 Dancer Thread

    Todd thanks again for asking me some questions Ok so here is the update it sees both engines The Garmin is set with 2 engines and there are two columns for all data however, if I start the STBD engine it shows the data in engine 1 if while the STBD Engine is running I start the PORT engine...
  5. Steven Sanchez

    Official 320 Dancer Thread

    Thank you Craig for your reply - i have heard this about both being set to STBD and having to set one to port. How do I check the Network Log? :) sorry if that is a dumb question - just not sure how to do it
  6. Steven Sanchez

    Official 320 Dancer Thread

    Todd thanks for your email and helping out Part numbers 2ea 84-879981T20 - 20 ft. (6.1 meter) SmartCraft data harness non DTS with (1) termination resistor 1ea 878492K14 - 4-port Junction Box Kit with weather caps 1ea 8M0165589 - NMEA 2000 Gateway Module Assembly CAN P Multiengine & CAN H...
  7. Steven Sanchez

    Official 320 Dancer Thread

    Vessel View with Garmin in 2003 Dancer with 350 MAG MPI I recently had all the parts installed for Vessel View to work with my Garmin through NMEA 2000 connectors - diagram below - here is the problem - I am only seeing one engine - not sure why - checked everything the cables have the...
  8. Steven Sanchez

    Official 320 Dancer Thread

    Phase 2 of the boat - new helm seats - all upholstery is in - next up flooring, bed, bedding and that darn wobbly table
  9. Steven Sanchez

    Total budget was over $35,000 if you want to see whole list of what was done email me at...

    Total budget was over $35,000 if you want to see whole list of what was done email me at ssanchezsr@verizon.net
  10. Steven Sanchez

    I did a lot more than this

    I did a lot more than this
  11. Steven Sanchez

    Official 320 Dancer Thread

    Phase 1 of the interior finally got some pictures to post More to come Phase 1 of the new interior to be followed very soon by All New Cockpit Carpeting All new Cabin Upholstery All new bedding and bed area It's gonna be Amazing! If you want to see it go to...
  12. Steven Sanchez

    Official 320 Dancer Thread

    Warning Label Replacement Does anyone know where a set of replacement stickers can be had - have a 2003 Sea Ray 320 - just finished a refurb these stickers look old with all the new and was hoping to replace - would be happy to buy a whole set - but specifically looking for the ones circled in...
  13. Steven Sanchez

    Factory full of Sea Ray Parts

    2003 320 DA I have a crack in this unit looking to replace - do you have or can you get
  14. Steven Sanchez

    Official 320 Dancer Thread

    Love the Flooring - would like to know how you did it and what the story is - interested in learning about it. PS - I did the same fridge upgrade and it also went flawlessly and was super easy upgrade. Although I bought the fridges in Feb and installed in May and when I opened it there was a...
  15. Steven Sanchez

    Official 320 Dancer Thread

    Hey guys I posted this a while back and didn't get any usable answers - I have a crack in this unit in my Sea Ray 320 2003 - looking to replace during off season while being completely renovated interior - any idea where I can get replacement or any ideas
  16. Steven Sanchez

    i would pay way more just not to buy ANYTHING made in China

    i would pay way more just not to buy ANYTHING made in China
  17. Steven Sanchez

    DougLas - I understand you sell LED underwater lighting - is that accurate - and if so can you...

    DougLas - I understand you sell LED underwater lighting - is that accurate - and if so can you give me some details - I am looking at the brightest I can get Blue - so the Lumen rating to me is super important THanks -Steve
  18. Steven Sanchez

    Official 320 Dancer Thread

    She is fantastic and has an unbelievable attention to detail and design element to her work - She is redoing all the upholstery in my entire boat - cabin, cockpit etc.. and all the bedding Go to her Facebook page and IM her - she is super responsive - tell her we talked (Steve Sanchez) - I...
  19. Steven Sanchez

    Official 320 Dancer Thread

    Here are the first pics of the new seats Should be done in 2 weeks. As soon as it comes out of storage - and COVID-19 allows us to go there Install all new fridges, GPS, Audio, Video, Bottom Paint, Restripe, Radar, TV, Teak Stairs, Carpet and a bunch of mechanical upgrades including new...
  20. Steven Sanchez

    Official 2003.5-2008 340 Sundancer Thread

    Richard Gooddale is fantastic I purchased new stairs and a head floor insert from him recently. Top notch product, pricing and customer service. cant wait to install in Spring
Back
Top