2000 310DA with a Westerbeke genny. It’s been running fine the three years we’ve owned the boat. Today, I started it up. I got no power to the panel When I switched from shore power the the generator. The volt meter read zero.
Any ideas what could be wrong?
I have a VG2 vacuflush in my 2000 310DA. The vac tank has the pump an bellows mounted on it. I replaced the pump and bellows as indicated by my SR Service Mgr and a call to Marine Sanitation. The pump was cycling very slow which they said it was on it’s last legs. It would take forever for it...
All, I thought I would post this here and not in the "Official" thread for my boat. In the 370 thread there were a couple of posts about the synch going crazy. Last year during the last run to storage our synch went crazy. It would bounce back and forth between port and starboard like it was...
Below are some pictures off my C120W install. Scott made some custom panels to accommodate the new MFD and relocating a bunch of switches. Here is a before and after look. To the Moderator, if this needs to be moved to another forum that's fine.
Use of hollow concrete blocks (HCB) during winter lay up has been discussed in a number of threads each fall. Here is a picture of a cracked block under a 370 Sundancer. This is not my boat, but a slip neighbor's a few years back. The blocks under the keel support the boat. The stands keep...
Here is how I installed my new salon TV.
Built a shelf and fastened it to the orginal tv slider board. Fastened the TV to "L" brackets. Through bolted the "L" bracket to the shelf unit. Installed into the hole.
I chose a TV with a flat bottom, so that it would sit on the shelf for...
Wes, Please move this to the Holding Tank, if it fits better there.
The end of Greg's (Mrs. Robinson) thread about Brokers got me thinking about what has been the longest thread I've seen.
I am crazy enough to also have a 60's era muscle car in addition to the boat. My favorite site...
Just wanted to post a fix for my open array (circa 1997) that would not spin after being launched this spring. I got a "Bearing Pulse Error" message on the screen. I checked the fuse in the panel. That was OK. I even replaced it with a new one. Made sure the unit was turned on on the back of...
I need some help from the 370DA owners. Where can I store the larger almost square filler cushion from the mid-cabin berth? I put the smaller 1/2 circle cushion under the seating on the port side of the mid-cabin. I can't seem to figure out where this larger one can fit.
I went the my SR Dealer in Michigan City, IN for their Spring open house last weekend. To my surprise my kids are in a picture on the inside front cover of both the Yacht and Sport Yacht brochures. The picture was from a few years ago when they took the Kids Safe Boating class.
My son now...
I need to get a new holding tank. The SR dealer wants the dimensions, so that the correct one is ordered. Their parts catalog only shows a 40 gal tank without dimensions. My current tank is not orignal, so would anyone have an orignal or OEM replacement 40 gal tank that I sould get the...
I bought this canvas last summer from another CSR member. Unfortunately, it does not fit on my 1997 370 Sundancer. It is Linen Tweed. Prior to the purchase I called SR and was told that the part number was the same, so I bought it. The radar arch was changed in 1998, and it doesn't fit. I...
I had an oil analysis done on a 370DA that we are looking at buying. Both engines had very similar results.
The one thing that I had a question about was % of water by volume. The Port engine had 0.28% and the Stbd engine had 0.24%. This is 28 and 24 hundreths of one percent.
Can this...
We are considering moving from our 330 to a 370. Are there any issues with this model that stick out as problems? We are going to have hull/condition and engine/mechanical surveys. It has 450hrs, 7.4 MPIs, genny.