Sure, sorry.
Here's one of the windows. Each of them also has the same trim inside. All of the windows are fine, but most of the trim pieces are cracked or broken. I do have one or two that is not broken. I was thinking about having them 3D printed (or using that as an excuse to buy a 3D...
Don't laugh too loud...I put in the 2 acre pond to test the motors (I only had one of those fins to use) and of course to drive in a couple of circles, just to say "I did it!"
Does anyone know where to get these? Or,has anyone been able to 3D print window moldings?
I need the inside and outside rings for almost all my windows.
You can see the boat in the photo.
Thanks!
I have the orginal stove that came in a 1975 Sea Ray SRV 240 Sundancer that I am in the process of restoring. It is not going back into the boat. PM me if you are interested before it ends up in a land fill.
No money, just good karma...and if you happen to have a copy of an owner's manual or...
Does anyone out there have a manual for a 1975 SRV 240 Sundancer? Or anything close to it?
I'm in the middle of restoring the interior and I could really use some help in identifying some of the wiring and plumbing.
Thanks so much!
UPDATE: Check out this photo of the HIN and the pond test!
I just picked up the same boat!
The seller said it was a 1975 Sea Ray SRV 240 Cuddy Cabin, but I can't find any reference to a 1975 model. I think it is a 1976.
The windshield angles toward the sea. I haven't found any reference to a similar boat.
Here's a Pic.