I seem to recall that it takes 1/4" packing. As for the cutlass bearings, mine are 1-1/2" ID (shaft size) X 1-3/4" OD X 6" long. There are 10 flutes in the bearing.
I have a 1988 390EC with the 3208 Cats. Running 20 X 25 NiBrAl props.
Awesome boat. Welcome to the party!
Thank you! I have the one in the second link. Had to order the K&N cleaner from Advance auto, but it works great! Tried it on one and I can actually see light through the filter now. I have to get to the boat and install it and grab the other one. Repeat. Rinse, etc.
Hi ya'll. We brought our '88 390 EC down from Rhode Island last October through Long Island sound. We hired a licensed captain to get us from RI to New Jersey through the sound. Ran 3'-5', sometimes 6' seas, windy, overcast, some rain, and ran 17 - 20 knots. She took a decent pounding but never...
Cleaning things up in the engine room I discovered there is a type of air filter installed on the Caterpillar 3208 turbo diesel air intake. Earlier I had asked my local marina shop about replacement air filter elements and they said those engines don't normally have air filters.
The filter is...
I figured as much. I was thinking of using a coring bit to pull a plug out, let it drain and dry out some while I wasn't using it and then putting the plug back in with some 4200. Another thought was that since on my boat the area below the tank, with the foam, is sealed on all sides it wouldn't...
Problem - Replacement tank is almost up against bulkhead. No room to drill without removing tank. Still don't understand why can't drill through bulkhead to drain water until I can pull tank.
Why is this bad? Po replaced the tank with a poly, but apparently left the water in that space below the tank. Considering drilling the holes to drain the water without haviing to remove the tank. Again, why would this be bad as an interim measure?
I have an '88 390 with the 3208 Cats. I have a question for the world's leading authority on restoring the EC. When we bought the boat it was bone dry and surveyed above average. Just recently checked the center compartment and found water in there. Already has a poly tank.
No ports yet...
Pietro,
Mer-Sea Monster here, I am hoping you can provide some insight.
Relatively new to this forum and have been reading the posts about water in the center section.
When we bought the boat (88 390 EC, 3208 Cats) last October it was bone dry. Had it out of the water Nov-Jan 19. Splashed at...
Mer-Sea Monster here,
Relatively new to this forum and have been reading the posts about water in the center section.
When we bought the boat (88 390 EC, 3208 Cats) last October it was bone dry. Had it out of the water Nov-Jan 19. Splashed at the end of January and in a Marina since. Just...