Search results

Vessel view 1.5 is not reading starboard engine. Looking for a replacement. Is a new version plug and play? Does it require additional harnesses? I’m in a bind. The boat is going on the market and this just failed. We’ve swapped Medusa harness, sim modules, all the terminators and resistors...

Vessel view 1.5 is not reading starboard engine. Looking for a replacement. Is a new version plug and play? Does it require additional harnesses? I’m in a bind. The boat is going on the market and this just failed. We’ve swapped Medusa harness, sim modules, all the terminators and resistors...

Has anyone purchased a swim platform from swimplatforms.com? We’re on the verge of buying a job-hydraulic version for a tender. Would like to get some input on the company or the quality of the product. Thanks

Anyone with an 06-09 40 add a swim platform? If so have you had any issues. We’re looking into adding one from swimplatformsinc and then adding a tender. We have an ‘08 40 with 425HO’s

For those who have done it my question is the routing of the wires on a 40. The cable box sits port side forward of the sink. Is the cable routing intuitive and solely on the port side above the TV, microwave and above/next to the storage in the cockpit area?

Has anyone replaced at wiper motor on an 06-08 40? Port side motor.

As you can see from the pics I have rust around the metal frame. What have y’all done to remedy this. The fridge works great so replacing is not the goal at the moment.

This is my first diesel boat and I’m having trouble finding some information. For reference, 08 40 w/Cummins QSB 5.9 420 HO I’d like specific information on cruising RPM. The broker told me to cruise at 2400 but where is that written? What temp is too hot? What load percentage is too high? I...

Has anyone changed the pitch of the props for the sole purpose of increasing speed? Also, has anyone increased the size of their trim tabs. if so what were your results?

How long does the water heater take to warm up the water for a shower. We’ve never used ours because we mostly use the transom shower and the water is warm enough from the engines or genny running. For reference we have an Atwood water heater. Also, that warning about hydrogen gas build up. Is...

I know we get 10% with Custom Marine Carpet but does anyone know the code? The company requires it for the order. Thanks

Do we get one as CR members?

Be careful. That’s all is have to say. I had a canvas company come out to fix my snaps and redrill a few that broke off and, BAM, the window shattered. These guys are good and it’s an honest mistake so just a heads up to anyone trying to tap the metal frame.

https://www.aridbilgesystems.com Thoughts, anyone use them? Got some friends at Hinckley who are installing this product on new boats. They swear by it.

What bulbs have you guys used in these fixtures. I’m having trouble finding a suitable bi-pin G4 bulb that fits. The 3mm length of the bulb is limiting. Suggestions?

Clean shower sump box that is working but the compartment aft of that has water.

On my 40 the toilet has a red and green light for when you can flush. The light is staying red and won’t go green. Is this indicating a clog or a pressure issue? The tank is not indicating any amount and the water is full. There doesn’t appear to be any leaks in the ER and there is pressure to...

'08 40. The starboard side GFI keeps tripping and won't reset. When connected to shore power is the GFI is reset the 50amp shore power breaker trips. Can anyone think of why? Could the vacuum be causing problems? Port side GFI works as do the outlets. All new shore cables as well.

Is there one? Any interest in starting one?

I need to replace the wiper blades on this new to me ‘08 before my trip back but I can’t get to the boat before I close. Can anyone provide any specifics on what style of wipers I can use? Sea Ray manual says “WIPER BLADE 20” FLEX”. On my previous ‘07 340 I just used automobile wipers.