Search results

  1. villain style

    No depth reading on Raymarine E120

    Last year replaced both Raymarine E120 with used E120s. Néw used Dieselcraft also. Have cleaned all connections behind Dieselcraft to gauges. As far as can tell everything works except depth reading. I have the depth display on Chartplotters but it just says “Depth - -“ on each Chartplotter...
  2. villain style

    Bypass heater question

    Years past I would drain water tank. With valve open I would then connect air compressor to shore water inlet and blow out all faucets. When done I close heater drain valve. Then i would add antifreeze thru strainer for engines. I never had antifreeze fill heater back up that I’m aware of...
  3. villain style

    Fast flash on Charger

    My charger is blinking fast. Charger says fast flash = full charge. Does that mean the batteries are fully charged or the charger is giving them a full charge?
  4. villain style

    Surge protector

    Anyone have a surge protector added to their electric pedestal before your 30 amp cords. If so what are you using? These things sound like a good idea Since I just watched a wave of lightning storms roll thru marina the past 2 hours.
  5. villain style

    Cold water line leaking help

    So today I decided to replace the kitchen faucet with a new one. The old one would not provide any pressure. I hooked the new one and the pressure was great. Then I had a leak start at the black thumb screw in the brass fitting. I used Teflon tape to start with and leaked so i tried it...
  6. villain style

    Cabin Flooring - Anyone recognize this 420/44 DA flooring?

    Am considering Amtico for cabin flooring. I found this picture but have no idea who's it is or the flooring manufacturing/color specs that it is. Anyone have any experience/comments with Amtico? Would love to see your pics and hear of the particular floor you used too...
  7. villain style

    SmartCraft_Diesel View help

    All year my Port 4 in 1 Cluster gauges and Tachometer have worked intermittently. The DieselView also only had the Stbd data working. Started intermittent in June and by August no Port data or Port gauges worked. I had multiple times taken all the connections apart and cleaned them at the...
  8. villain style

    Shower Sump mystery

    My shower sump has me stumped. during a shower it Comes on goes off comes on goes off working as it should. Then after 5-10 cycles the pump comes on but does not discharge the water. So now the pump is running and the shower sump box begins to overflow. I have installed brand new pump, float...
  9. villain style

    Pfifertex Plus VS Soltis for Window Sunscreen

    I'm looking to get my windows covered and was looking for some feedback from those that have these? Pros and Cons? The color and % sunblock that you chose? They both appear to be good products... Thanks -
  10. villain style

    Smartcraft replacement Companies

    Thinking about swapping out my existing Smartcraft electronics for SMX. Does anyone know any local Service companies or Techs that specialize in this?
  11. villain style

    Why do I have Diesel View Calibration on SystemView

    Does anyone know why I would get a Diesel View Calibration screen on my System View? It’s as if it’s an initial setup. Any ideas how I can exit the screen or should I just go thru the startup calibration process?
  12. villain style

    Master reset process for smart craft 5000

    anyone know it?
  13. villain style

    Vessel View not working and Gauges fluctuating

    Over the past couple weeks my Port gauge cluster would sometimes not work when I started the engine. I would turn engine off and restart and it would begin working. Now yesterday Port gauges not working, Stbd gauge cluster fluctuating all over the place, and Vessel View starts up with "Diesel...
  14. villain style

    How to remove Smartcraft device?

    I would like to remove my Smartcraft device from the dash and make sure I have clean connections. The reason I want to do this is because the Port gauge cluster and tachometer decided to not function today at all. The needles make a small move when toggle is at start position but nothing...
  15. villain style

    Clearwater FL short term rental?

    My daughter has a residency at Morton Plant Hospital this January 2020 thru April 2020. She needs a place to stay that is nearby and safe. Would anyone have any suggestions or places available for her to rent? Thank you.
  16. villain style

    Hurricane Michael in Panhandle

    To all our Forum friends in the Panhandle I hope you have prepared and are in a safe place and that your boats fair well.
  17. villain style

    AC Marine Dealers?

    Not sure how active Beard Marine is with the forum and was curious if there are any other companies specializing in AC units that might be a good option with competitive pricing for our group?
  18. villain style

    MarinAire Air Conditioner Units? Any one install this brand?

    Looking for some feedback from any one who may have replaced their original CruisAir/Dometic AC units with this brand? Looking for feedback on your experience and satisfaction with them. Thanks - https://www.marinaire.com/Products-s/12.htm
  19. villain style

    A/C service companies near Kent Island?

    Looking for suggestions to Companies that have replaced your A/C units in your boat? Any recommendations?
  20. villain style

    Stolen 340

    i heard a 340 was stolen out of the Annapolis area today. Anyone have any more details. Hope they get her back soon to the owner.
Back
Top