Search results

Hi, If no bulsa in hull you can also mount in bilge under motor with sika flex no problem at all and no drilling of transom. Cheers Crofty.

You check compressions on all cylinders?

Hi there, if you have not solved your issue yet, check the shift switch as if this has failed it will be telling the PCM that the motor is in neutral and will not let you rev beyond 3500rpm. Good luck

Hi, check fuel pick up at the tank as if it is picking from the same tank as the motor then Sea ray may have a short pick up for the genset. This prevents you from funning the tank dry usually half of the tank, anything bellow that and the geni will run dry hence the genset not starting. Just...

Hi There Check shower box under the entry steps to the cabin, the float switch for the pump may have failed allowing the water to wet the carpets. Check galley water connections where they connect to the facet along with the one in the head. If all these check out ok check the join between the...

HI There Check under master bed. They normaly place the batteries as close as they can to the bow thruster to avoid voltage drop etc. Cheers, and happy boating

Hi There The B3 had an issue with this in that the oil in the gear box was pushed out through the seal on the prop shaft. Mercury have changed the seal used on the shaft. Contact your dealer and haver them replace this seal and this will solve the oil loss. Happy boating from down under