Search results

2000 310 5.7s/B3s. Good morning. I've been dealing with dead battery issues recently. I have a ProMariner ProSport12 charger. The AC Power light is on but none of the other lights (i.e. Charge Mode, Battery Type...) are on. Is it the charger?

2000 310. I'm missing four of the short, hex head bolts that connect the extensions to the main section and slide up and down. I went to West and got close but the bolts were too long. Any ideas on where I need to go?

2000 319 w/5.7/B3s. The bottom of my waste holding tank is leaking. The waste mechanic and I looked at it yesterday. It is definitely coming from the bottom, not the top. The next step is to remove the waste tank, which I don't think will be too difficult. I called Sealand/Dometic and they...

2000 310/5.7s/B3s. My outdrive reservoir has been leaking drastically into the bilge. The reservoir is totally wet from the top down. I removed it, cleaned it, dried it, put it back on, refilled it, took it out for about 45 minutes, came back, almost totally empty. The bottle was covered...

I have the 210 VHF radio but, of course, it does not have the microphone. Looking for the microphone or the whole radio with a microphone.

2000 310 with twin 5.7 TBI B3s. My starboard engine raw water pump is leaking out of the weep hole. This is the pump that has the raw water impeller. Not the water pump on the engine. Should I get a reman or new? Where? I don’t have the presses to rebuild myself. Thank you.

2000 310/twin 5.7s/B3s. My mechanic told me that I have a bad ECM and that the part is no longer made. He said a company in CA can try to rebuild it but that there is no guarantee. What are my options? :(

2000 310w/twin 5.7 EFI/TBI. My boat is in the shop getting new couplers :( I've been doing research on parts in general and I keep getting asked my engine serial numbers. Based on the tags just above the starters, my serial numbers are L634499 and L634497. Some sites don't recognize those...

2000 310w/twin 5.7TBI/B3s/450hrs. Short story, both engines will be pulled for coupler replacements. As long as the engines are out, what else should I have the mechanic look for or do that might be more preventative maintenance or visual inspections?

2000 310 with twin 5.7 TBI B3s. I hear the starboard engine prime after turning on the ignition switch and prior to engaging the starter. I do not hear a priming sound coming from my port engine though. The port engine takes several attempts to get it running but the starboard motor fires...

2000 310. Getting rid of the PO's attempt to tape on velcro to seat bottom and cushion bottom and take everything back to OEM. What are the round plastic(?) Velcro hooks that are screwed into the fiberglass seat bottoms? I've looked all over the internet and can't find anything. The ones on...

2000 310 with twin 5.7s/B3s with 400 hours on each. Started up both motors, had propulsion from both outdrives when motoring through the no wake zone, powered up to get on plane and heard an odd noise. Starboard motor RPMs jumped way up and the boat slowed down. I put everything in neutral...

Accidently posted my question twice. Trying to delete this one.

We bought the boat used and the PO had the wrong table in it. :(