Search results

The fiberglass on the arch of your 330 is plenty thick to support the weight of any tv....and then some. The Ram-Mounts use 3 or 4 bolts (I like to use 1/4-20 stainless hardware) when combined with large fender washers (1.5-2" diameter) This is VERY strong..... I also put weather proof coax...

it does not require a motor pull, although a motor pull is an easier job! ;-) there is no problem with the plastic plugs, I have done a few of them myself without an issue.

often times people can confuse clean oil with oil+water (which tends to look like chocolate milk) Just wanting to make sure he has eliminated the water-intrusion possibility.

A good place to start would be doing a compression test. From there I would check your ignition timing, and make sure your distributor isn't loose.... I find it hard to believe that your motor would have an internal issue like you describe, and still idle/run at low speed fine. Does the oil...

I like to use the Ram-mounts ( http://www.ram-mount.com/ ), they are great, and as you can see in the pictures on my other post....they easily hold a 26" w/dvd player. http://clubsearay.com/forum/showthread.php?t=12164

I have had very good luck with the cheaper line of 'Insignia' TVs from Best Buy with built in DVD players. Unfortunately, with these you will need to use an AC inverter to run them, but a small 400watt model is more than enough and are very cheap. Below is an example of one I installed on a...

If you fully charge a battery in sound condition, it will easily hold its charge through the winter by simply unhooking the negative cable.

There are a few special mercury tools you will need when replacing these parts...which you can probably source elsewhere for cheaper. The hinge pins use a very large drive socket (similar to torx), as well as the bellows tools which greatly simplify the installation of the bellows...