I would suggest two things to help.. 1-when the outside temps are remotely cool, rapidly pump the throttle handle several times from Nuetral to full throttle before attempting a start. 2-Your choke may not be adjusted properly. This is accomplished by loosening the retaining screws on the...
with the engine completely warmed up to operating temperture, turn the mixture screw clockwise slowly until you hear a decrease in RPM. Not the position of the screw at this point. Next.....turn the mixture screw counterclockwise until you hear a decrease in RPM. Note the position of the...
Fuel filter clogged and not allowing full fuel flow?
Prop in good condition without bent blades or major damage?
The trim button on the throttle lever make a huge difference in top speed. Generally I have to give full down trim until I get up to about 30 mph then I can bring the trim about...
My first thought is something wrong with the carb re-build. Most likely a lean mixture caused by a vacuum leak between the carb and manifold, vacuum hose off or leaking or improper re-assembly. Another possibility would be the accellorator pump in the carb is not working or not adjusted...
My two cents......I have a 2001 bowrider 18 foot with the 135 hp 4 cyl and boat at higher altidudes from 6500 to 4,000 ft. I like the Mercury Black Max aluminum three blade prop for all around performance vs cost. They are easy to find and work well. I do not like the re-conditioning process...
Thanks for the replies. We are thinking of the Punta Gorda General area or around Charolette harbor. We are currently in Utah and I have a lot of sailing and a good amount of power boating experience. But.......none in salt water. I am looking to make the move in a couple of years and am...
I am thinking of moving to Florida with my woman and Bowrider 180. Anyone live down there or close that has experience on how my little freshwater boad would do out in that area?
I have an 01 180 Bow Rider. I han hit 39 mph (GPS) with one person on board. 33 to 35 with the five to 6 person load you are talking about. Assuming none of your people are huge :) BTW....my speedometer on my boat is about three MPH slow so I wouldn't stake your opinion based on what the...
The hex shaped brass screw on the right side of your 1st carb picture is the idle speed adjusment screw. If you turn in counter clockwise, your engine speed should slow down at idle. Correct idle speed is approx. 750 RPM. If you idle speed does not change when you turn this screw, your...
How do you think I got those things in the bow of my boat. They were initially attracted to my shiny stainless prop. Then I had to win them over with my attention to detail and meticulous maintenance habits. I'm getting old now and have to keep the prop shiny as a back up chick magnet.
Oh...
Actually since I have a small trailer boat and it sits on the trailer most of the time, lots of people see it. Everytime I am on the road the person directly behind me at stoplights will have the nasty looking prop staring them in the face.
Plus, with the amount of dull build up I had on the...
I have a stainless prop that was highly polished and looked brand new. I took the boat to Lake Powell (Fresh Water) and had it in the water for three days. When I pulled it out the prop was no longer polished and had a very dull coating of minerals or crud, (technical term). Anyone know an...