Search results

Yes I've already considered replacing it. Just maybe someone has gone thru the same thing maybe finding this and that down below. Just sharing info.

I used to stationary engineer 19 years, propulsion engineer 12 years, engineering tech rep 6 years, just wanting to know if any body has any info on past experience of anything else in the bilges cause I havent found anything yet.

Understand but it directly goes to the batterys.

The charger is only a charger 30 amp 2 legs, original equipment I do know all that, what I'm trying to find is there a converter involved and where located.

Ok will do the charger is original factory equipment

I understand what you are is that of no schematics was just wondering if anyone knows for sure of a converter?

Yes sure

Okay the way I see it is there is an original 30 amp to leg battery charger going into 3 battery parallel battery switches on both batteries circuit breaker panel feeding off of batteries / battery switches

Yes I understand that it is a circuit breaker panel I am qualified 480 volts three phase but I'm used to seeing a schematic

Okay this is what I have in between my battery switches and it is original

Does anybody know where the 110/12 volt convertor is on a 1992 Sea Ray Sundancer 300?

Does anybody know where the converter is at on this 1992 Sea Ray Sundancer 300?

as far as electrical drawings for the Sea Ray Sea Ray says no can do I have a feeling because Michigan wiring was involved. I'll see if I can find anything else on their website I'm not holding my breath though

Okay to start with does anybody know where the fresh water pump is located on the 1992 Sea Ray Sundancer 300?

Does anybody know if the freshwater Pump on a 1992 sea ray sundancer 300 is fused anywhere? Thanks in advance for any help.

Any suggestions on where and what to buy 4 replacement reefer standard Mini I know norcold is out there any suggestions will be appreciated thank you

Power supply has two fuses one standard and 1 Mini fuse both fuses tested fine continuity looks like I got a bum refer, bummer.

Yes thanks, now the question is is the power supply on the refrigerator fused

Replaced the lid micro switch I have power to the refer both 120 and 12v so now I have to look in to the refer

Update: Stove Works, Now going to pull fridge.