Here I am siting in the sun on my patio
Having a margarita but
Not on my boat out on the lake..
AGAIN...the outdrive saga has reared its ugly head Again..
Bought a rebuilt upper and lower B3 at 2.20 Ratio, I run 22p 3 blade merc props.
A few summers ago...original drive unit failed and I went...
Here I am siting in the sun on my patio
Having a margarita but
Not on my boat out on the lake..
AGAIN...the outdrive saga has reared its ugly head Again..
Bought a rebuilt upper and lower B3 at 2.20 Ratio, I run 22p 3 blade merc props.
Three summers ago...first unit
I have to replace my transducer and am wondering
What angle of deadrise the 02 - SD260 hull is at location of the factory through hull ( 10 inches right of centerline ) I recall reading somewhere it is 21 deg. But I can't find that info.
I Need to order correct transducer..
thanks for any help.
Just wondering how to safely rig a temporary
Remote start switch on engine in order to bump
Motor over?
So I can do a gimble to engine coupler alighnment.
A month ago or so while towing grandkids around for an hour or so I noticed a slight change in vibration/ noise while in gear up at 2500 + rpms, this along with an oil in bilge issue, which I did solve( seperate thread ) has kept our boat close to our marina. Before I haul her out, I ran in...
Been a few months since my last newbie question.
All Boat systems have been running ok since may 15th splash day..have put on 30hrs running at diff throttle positions.
Untill a week or so ago..after a couple hrs
Towing a tube with my son and grandsons around ..1200 to 3500 rpm..all good..oil...
I'm trying to rig up my new to me 260da for some trolling for salmon but mostly rainbow trout. I want transfer both my two elec scotty down riggers from my old 21 ft boat.
Im trying to keep the gunnel set up as clean as possible while riggers removed and are stored.
I intended to remove the...
I have noticed that my trimtabs retract and stop each at a different points.
The port cylinder ram stays out an inch further than starboard when fully retracted. 11.5" O/L vs 10.5" O/L
My question is, Did Sea ray ever install rams of different lengths? Ie: to lift/trim extra port side weight...
We are now owners of a pretty nice 2002 260 Sundancer
Hoping for a few more 13+ degree days to enjoy her before the winter haulout begins..
Hello to everyone