Shaps I can't thank you enough. Today I
went into vessel assist 4 and changed the
source for the zeus tabs to TVM and they
work. If you could see the smile on my face
Thank you so much for tuning into the forum
Jedd in Vancouver
Thanks for all the info . I am in Vancouver BC, CANADA. The problem is when i activate the trim tab switches on the dash nothing registers on the vessel assist screen or the DATA screen of the Raymarine MFD. The bar graphs don’t register any movement where it used to tell me how much tab...
Hi Shaps; thanks for responding. May I ask where is the power package located ? Is there a manual that explains how to reset the trim tabs ? How do you identify the manual over ride in the engine room and will resetting it restore my trim tabs. I have had a very bad experience with the local...
Hello folks; my mechanic says I have Zeus trim tabs not Bennett and doesn’t know how to reset them since they stopped working. Any ideas ? The boat is a 2014 510 fly
Thanks Jedd
Thank you all for advice . Everything suggested was checked. The regional (state) rep came to the boat in Vancouver BC and connected directly to software engineer in Wisconsin who was working from home . After an hour the problem was found to be the flybridge trakpad was
connected to the inside...
The local merc marine distributor and my mechanic are arranging a teleconference next week with the marine engineer at Fond du Lac headquarters in Wisconsin. Their tech support guy sent the personality file for the boat which didn’t fix the problem to his dismay so he moved us on to the...
I am getting an accurate position on the smartcraft vessel assist 4 which
is the same as the Raynarine chart plotter. So it appears the GPS antenna is good.
Is the IMU mentioned the flex gate compass which I found
Under the fly bridge console with a y harness to the GPS antenna and the
smart raft vessel assist 4 ?
Hello everyone. I have a 2014 SeaRay 510 fly. I recently lost my autopilot and skyhook .
The mercury tech can’t find the problem . I feel it is something simple. Has anyone had this problem. Also does this model have a flux gate compass and where is it located. Finally should I calibrate the...