2007 Sea Ray Sedan Bridge Upgrades:
I'm looking to upgrade/replace a few items on my boat this fall and was curious to know what others have done.
1.) Replace/Upgrade the AC system. My AC units are corroded and need to be replaced. I'm planning on doing a direct replacement Marine Air 16,000...
Hello,
I'm starting a new thread as the other one I made got lost with the hydro lock issue.
I just installed all new risers, manifolds, plugs and wires. Took the boat out for a run and it ran awesome for 20-30 min. As soon as I took it above 3,600rpms, then a loud beep and both engines...
Yes, they were OEM but the boat was on the gulf side of Florida and sat in the water all year. I believe the salt content in the gulf is very high as well. I will make sure to spray the outside with an anti corrison spray and keep an eye on them now. Too expensive to replace every 4 years
I have a receipt of the risers and manifolds being replaced in 2016 at 485 hours(before I owned the boat). The boat had 557 hours when I purchased (Dec 2017) it now has 785 hours. The risers looked ok but the manifolds were horrible.
Update... Rookie mistake but man am I glad it was just my mistake. This week I went down and decided to pull the wire off the coil and see if the sound changes. Nothing changed but when I looked at the plug wires I noticed I had the two cylinders swapped. I swapped them back and boom knock went...
I have an 07 Sea Ray Sedan Bridge 36. Two weeks, I came into the dock after a nice run. Shut the engines off and waited for some friends maybe an hour or two. Went to restart the boat and port engine fired right up, starboard turned a small amount and then clicked. I pulled the plugs and water...
When were your fuel filters last changed? When I bought my boat upon survey we could not get it to go over 3,300 rpms and it would drop 100-200 and bounce around. I used that to my advantage and the previous owner did not want to look into it. His loss save me tons of $$$ and some new pre fuel...
Lots of things contribute to performance...this is where I’m at.
2007 Sea Ray 360 8.1S
3500rpms 16-17 knots 46-47gph
3900rpms 20-21 knots 54-56gph
4200rpms 24-25 knots 60-62gph
I never really take her over 3,900rpms. Engine temp normally 170-178
I currently have my 07 360 Sedan in North East, MD. We are possibly looking at changing marinas. We have to have a pool for kids. I drive from Lancaster, PA and not looking to drive another hr or two so prob looking at the sassafras river, bohemia river, Chesapeake City or Elkton area. Looking...
I just purchased the boat 6 months ago and now it just started but during a hard rain water will start building up in the center at the rear sliding doors. I know for a fact the rain water is not coming through the rear sliding doors. It seems to be coming from the port side and running along...
I'm having an issue with my underwater hull lights coming on all by themselves. I think I narrowed it down to the switch panel at the top of the stairs on the bridge. It is a Sea Ray Part Number 1816878 Module, EDS 4-SW. I called Marine Max and they do not have one. They contacted Sea Ray and...
Well I never did a trip like this before....but I can tell you I learned a lot. The biggest thing is time. The trip would have been much more enjoyable if I had more time but my vacation time was limited. I would never suggest booking slips ahead of time. I would have a goal destination in mind...
Thank you so much for all the help. I will be ordering these once I go over the boat and make sure the lighting is the same!! I think it is pretty close! Thanks again.