Search results

I think I know this answer, but let me have it. Mercruiser 5.0 MPI I/O I winterized, changed gear lube, filled reservoir. Idled 3 hes to new marina. Gear lube reservoir is empty. Im certain the plug is in. Complete lower?

I have 2 Cable clams for sale: SeaView Cable Gland for multiple wires - $25 shipped Blue Sea cable clam for single wire - $12 shipped $30 for both shipped.

We are considering a move that would put us in the Sacramento area. What are good options for weekend boating? We have a 310 DA that I would like to bring with, but with IOs itll have to stay freshwater. We really like the boat and dont want to downsize. We like 2 day trips, exploring...

The table at our rear deck seating is mounted with a straight pole. Since the deck is also slanted back the table is not level. Has anyone bent the pole or made a custom one so the table is level?

I am installing LEDs ynder the swim platform. So far the lights are mounted and the wires are run to the transformer/ power supply. The switch I bought lights up when activated...a few extra wires I guess. The horrible drawing shows what I need to figure out: Connect Red/Black Power Supply...

I installed 2 of 3 batteries today. The third fluid level was way down over the winter trickle charge...I added 3/4 gallon of distilled water to it and put it back on trickle. I wont be surprised if I have to buy a new one. But...after installing 2 batteries and turning on my battery master i...

My marina on the St. Croix River reached out today and said I have this week to get the boat ready to float. With the river coming up 1 foot per day they estimate to lose the parking lot by the end of next week. Headed there tomorrow to unwrap, install plugs, batteries, check bilges and get...

It’s still a high of 21 this week, low of -21, but Im ready for spring. 310 Sundancer that was professionally wrapped for the bargain price of $600 here in Minnesota. I know it only shrinks once, but has anyone reused their wrap for a boat this size? If so, what’s the process and how did it...

Was wondering what kind of hours people have on their gas engines and conditions. I have Mercruiser 5.0 BIIIs with 850 hours. Freshwater river boat and putzing rpms most of the time.

We've been entertaining the idea of renting our 2002 310 DA out, perhaps on a monthly basis. We don't want short turnovers of weekly rentals. Boating season is so short here (May-Oct) that maybe others don't want to own one but still want the experience. We're on the St. Croix based in Afton...

I have 2002 Mercruiser 5.0 MPI sterndrives. Winterinzed it today and had an issue with 1 thermostat drain plug. It seems the thermostat drain plugs are different size than the 3 block drain plugs. Does anyone have a part number for these? I purchased a replacement block drain plug and it...

We purchased our 310 Sundancer with every expectation of sleeping on it most summer weekends and weekdays. We quickly realized that we drastically underestimated our 10 year old daughters grumpiness when boating without friends. Weve brought some of her friends, but are looking for others who...

If youre looking for a way yo hold a few rods these may do it for you. The picture shows attached to the swim platform rail when I bought it...I don’t fish. Both are in excellent condition. $80 for both shipped.

I have an Atwood water heater with both electric and engine heating (apparently). The water heater will be replaced sobIm fully bypassing it. I connected the red to blue, cold water feeds the hot water lines now. How are the two engine lines affected? Ive disconnected them but dont know what...

During oil change (new owner) I saw a thin Motorola branded device on my stbd engine. Merc 5.0 MPIs on a 2002 310 DA. Upper port side of the stbd engine near the transom. I forgot to look for the same on the port engine. What it is?

Just purchased a 2002 Sundancer 310 with 5.7L bravo 3s. The boat looks about 2 years old with some minor work in progress. The main cabin door had a blown out truck. I disassembled it and am waiting on a new truck. I can’t find the brown caulk to replace the outer lid. The Ray 230 vhf cord...