Search results

So I did look into the throttle body and there was no muffler to be found so it bust have sucked it all the way in. Anyone else have any suggestions on why the alarm would continue to go off?

I did put in a new muffler. The old one was gone so I figured it got sucked in. I pulled the rubber hose and it was clear. So now I should pull the cover off the front and see if it’s in there?

I have a 2006 340. The IAC alarm went off on the port side, also it was doing the usual, not being able to idle without dying. I replaced the IAC and the idling is back to normal but the alarm continues to go off. I have reset the guardian a few time along with shut the power off on the...

I know this is an old post but, I have 8.1’s also. My IAC alarm is going off so I replaced the IAC. I put a new one on and the alarm never turned off even after resetting. So I swapped it with the side I know works and still the same. The motor is running fine doesn’t stall anymore. Anyone have...

No. Not yet. As of now I just turn the alarm off and keep going. If you get someone that can help let me know and I’ll do the same

Eddie I read your post in 2016. Did you replace your fuel pumps? I need to replace mine on my starboard side. Where are they located?

JJ I know this was a few years ago but how did everything work out? Did it quiet the generator down? Was it worth the money? Did you end up doing anything else? Thanks

Did you ever figure out what model charger you had?

No didn’t have it surveyed. So the only screws on the motor is the ground and hot. So put it with the ground?

It says fuel level CKT high

I know this is an old discussion but after I filled both my tanks full this happened to me. Anyone have an idea of what could cause the problem or how to get rid of the fault? I just brought the boat. It’s a 2006 340. Any suggestions would be appreciated!

Awesome! Don’t know why it would have been removed. I’ll put it on there. Thank you!

I recently purchased a 2006 Sea Ray 340. I looked down in the rope stow for the windlass and noticed a thick green wire that is not connected. It shows wear like it has been connected before, but cannot find where it goes. Windlass works good but sometimes trips breaker. Anyone know where this...