Hello all, I have a problem with my Starboard 357 MAG Bravo 4V carbureted engine with Bravo 3 Drive with about 180 hrs on it. Reverse does not engage until shifting is almost bottomed out. It does go into reverse but just barely then engages fully at bottom end of shifting. Engine also stalls at...
Contacted Kevin last week, unfortunately he did not have pattern for camper top/panels for 310 Sundancer so I would need to take boat to Long Island which is too far from where I’m at (approx. 3.5 to 4 hour boat ride). Just found out there is a local canvas shop just across the River from my...
Thanks for the info., Grec, Shaps and Kevin C. I had asked fellow boaters in Hudson valley last year for local reliable canvas person/company. Will call you guys in next few weeks as boat is still shrink wrapped. Thanks again!
Hello, not newbie to boating but picked up a new to me 1999 310. Picked her up late in the season last year (sept 2020). Looking for camper top hardware/canvas. Looked on eBay but no luck. Any advice would be appreciated.
Picked up my new to me 1999 310 Sundancer. Traveled from LI to Poughkeepsie NY. Took East River, down lower Manhattan, up Hudson River to Poughkeepsie. Great experience. Moved up from 2000 240 Sundancer.
Yes. Has bravo 3’s. Surveyor said props need to be cleaned/resurfaced... they didn’t look bad(no dings or chipped edges). Hopefully will pick up boat mid week.
Hello, Moved up recently from 2000 240 sundancer to 1999 310 stern drive Sundancer. Boat was repowered 2 years ago with 357 MAG Bravo 4V carb crate engines. I did a little research on pros and cons on both carb and fuel injection engines. Had survey/sea trial last week. During sea trial, she ran...
Good idea. I returned a few days later and engine started without a problem. I’m only running Refrigerator to keep beer cold and battery charger. Not sure if charger is original to boat. I’ll look into it. Thanks!
Cleaned area up and used mirror. Doesn’t seem to be leaking from pan. Spoke to marina mechanic and he stated oil lines by oil filter a known to leak. Placed absorption pads under engine and will monitor/check for wet spots.