Search results

Recently bought new canvas for my ‘98 330 Sundancer. Had to buy all the pieces so they would match. Therefore I have a Bimini and sunshade in pretty good shape. “Toasted Tweed” if anyone is interested.

Sea water pump was out. A few days for the pump to arrive and be installed and back in action.

Yes. Right on top on either side of the directional toggle.

Just bought a ‘98 330 Sundancer. Loving it so far. Awesome boat. Couple of questions. Why is the sweet spot operationally for rpms in cruise? Ie what rpm for best fuel economy. I filled the water system up and the filter keeps plugging up with fine black junk. Assuming it’s mold?? What’s the...

Just did this on my boat. Vertical was trashed. No chance of working. I’d check the switch first to make sure it’s not the problem. There are two 10amp fuses. One for verticals and one for horizontal. Check those first. If it’s not then you can replace it with a Jabsco (same as OEM) for around...

I think that was another member. Both of these engines have new impellers.

Just came out of a tune up at a reputable marina. Was running fine before the overheating.

The spotlight on my 1998 330 is shot. Light fixture is just wobbling on stand and won’t turn in. Will move horizontally but not vertically. Would like to replace the whole thing. Any suggestions? Thanks.

Well, a pretty inauspicious start to my 330 ownership experience. 30 minutes into first cruise, the port motor (7.4 Merc) overheated and quit. Limped back on the other one. It will fire but quits after a couple seconds. During that couple seconds makes a noise like compressed air escaping from a...

Probably internal corrosion. I just bought a boat that has that system but the radio (head) was gone. I was told they worked befor. Not using them anymore if you’re interested.

If anyone needs one, I have a couple. Just replaced my stereo system.

Great idea. I’ll give it a try. Thanks.

Great

Hmmm. I was assured by Lowrance tech support that it would work. Don’t really want wires out the back of the boat. What kind of transducer would work if not this one?

The unit is a Lowrance Elite-7 TI Med/High sonar. The transducer is the one that comes with it. Says it is 83/200,455/800.

Decided to go with shoot thru the hull. What kind of epoxy should I use? Should I build a little temporary frame to hold the epoxy to get it up on the shoulder of the transducer?

Just purchased a 1998 330 Sundancer. Has original electronics (Raymarine loran and depth finder. Depth finder doesn’t work). I would like to replace them with an inexpensive GPS/fishfinder/map combo. Boat is on an inland lake so don’t really need radar. Any suggestions! Also how to swap out the...

Possibly an impeller problem.