Search results

Hi, Still new to this and am away from my Searay Sundancer 29 (1992). I've been told that the anodes on my twin MerCruiser engineers need replacing. Would anyone know which twin engines came with the 1992 Sundancer. I see anode sets online for Mercury Alpha 1, Alpha 1 Gen 2 , Bravo 2/3 etc...

I'm not to familiar with osmosis on boats but I always thought it only effected the boats hull up to the water line mainly, I'm surprised that these photos are showing what looks like osmosis right up to the top?

Hi peeps, I just had my Sea Ray Sundancer 29 (1992) lifted to have it anti-fouled, and the chappie (after scrapping off the anti-foul), found lots of little blisters all over the hull. The boat had been sitting in the water (Sea) for 3 years (May be longer), and I brought her a few months...

UPDATE: Chris Lovell (Product Support @ Sea Ray) has just contacted me by email and stated that they have never used asbestos in any of their Sea Ray's. I was asking peeps here on ClubSeaRay if they knew if any Sear Rays were built using, or contained asbestos, the answer from Sea Ray is an...

Yes I may not use a pressure washer, and do it by hand instead, anyway I think a hand-held scrubbing brush will get into the non-slip better. It's only a Sundancer 29 so not to much work!!! ... and I can always stop for the occasional beer lol

FABULOUS... just the kind of reply I was hoping for, but would a £50ish high street retail pressure washer work well enough 120 Bar, or should I hire one and if so how much (I can actually check the cost myself lol)

Hi, The deck of my Sundancer 29 (1992) has not been properly cleaned for years (I gave it a wee scrub when I brought it a few months back), but it has some stubborn ingrained grime and dirt spots that need removing. Does anyone know of a good cleaner/shampoo that I can use to remove the...

Hi Guys, No need to get back to me, I ordered 1LT of each, and a pump spray can ... Hope the weather remains good the week after next :O)

OK guys I'm ready to buy some 303 canvas cleaner and re-proofer. Reading your conversation about the amount you have used, can you tell me how many 500ml bottles of EACH I would need to cover the whole of the hood. Here's the picture of my Sundancer 29 again. Indy

Hi, You've convinced me to take the canvas off whilst spraying with 303 Fabric Guard. So what should I use to clean off all the algae and guano, and there's lots & lots heavily embedded in the fabric (Possibly for at least 3 years) Any particular solution or would soap & water be enough? Indy

Hi, Thanks for your comments guys. Is there anything stopping me from cleaning/re-proofing the canopy in-situ or would I need to remove the canvas and clean them individually. In-situ I could just as easily cover all the canvas. Thanks, Indy

Sea Ray Sundancer 29 (1992) Looking for an approx cost to clean and re-proof a canopy in the UK I will be moving from Brighton to Portishead in one months time if anyone knows of someone who's reasonable at either location? I might do it myself (Weather good for another week or two), but...

It looks like it is only the screw cover foam that needs replacing, not the screw-back rubber/foam. My reason for wanting to do this was because I had a slight leak through the headliner and wanted to stop it before I put the final foam-backed vinyl up. It actually looks like the leak is...

Hi again, Both look good, and it looks like it's something I can do myself and save money. I'll check to see if there are a few youtube videos available. Many thanks LD Indy

Hi Little Ducky Thanks for your reply. To be fair I have no idea (All around all the windows by the looks of it), the photo I attached shows the rubberised seal is old and perishing (Looks and feels kind of spongy and looks like it's lost its surface - Look at the corners). I think I may be...

Hi, I recently brought a Sea Ray Sundancer 29 (1992) and am in need of replacing the rubberized seals around the flybridge windows (Think I termed that correctly!). I will probably but the seals myself and get someone to fit them. As I am new to this I suspect that the whole window section would...

The boat is being moved via a lorry to another marina so will be pressure washed immediately after lifting. Once the boat arrives at the new marina I want to have it antifouled before dropping in the water. The boat has not been to sea for approx 3 years, just left in the marina and there looks...

Hi, Any idea on the cost to antifoul a Sea Ray Sundancer 29 (1992), it has been in the water (Sea) for approx 3 years. Boat based in the UK Cheers, Indy

Hi, Any idea on the cost to antifoul a Sea Ray Sundancer 29 (1992), it has been in the water (Sea) for approx 3 years. Boat based in the UK Cheers, Indy

I was told yesterday by a guy who trailers boats around the UK that after the 4 ton mark, UK government road legal safety issues come into effect. May or may not be true but its the only comment I have as yet had. If there is anyone reading this from the UK who has transported a 4 ton...