As the title suggests, has anyone visited Lanier Marine Liquidators in Dawsonville, GA? I see some items in a parts boat I am interested in and am curious if anyone has purchased anything from them. Thank you in advance for your responses.
Steve
I have a similar situation. I am looking for an anchor hatch for my srv240. I've seen others remove the existing aluminum hatch frame and install a Bomar hatch of same size or cut a larger hole and install a hatch of a slightly larger size. I think I will end up doing that.
I know this is an old thread; however, I wanted to ask rawright if during your refurb of your boat, did you have to rebuild the engine cover or rear seats? Mine are missing and was hoping to hear of your experience, if you had to re-make them. thank you
The small wood piece over the gas tank does not belong there. I'm not sure where it belongs, it's only there now to assist in walking around. I'm going to have to have all the hatches and engine covers fabricated. I've been looking online for examples of above deck hatches from other Sea Ray...
Here is a photo of the door to the cabin. I will take some more pics showing the engine compartment, which is halfway below the rear deck. (and yes, I have some woodwork to do to bring it back to it's former glory)
Thank you all for your assistance. I've looked through all the '77-'79 brochures I could find;however, they all showed, IIRC, a flush deck rather than a raised engine hatch deck. This "lower" deck results in a taller sliding door to enter the cabin, which is different than the '78 240 shown in...
I just acquired a Sea Ray. It is approximately 25 feet long. The seller did not know alot about the boat, therefore, neither do I. It was advertised as a 1980 boat but I have my doubts. Most of the 240 models I've seen have a flush deck whereas this one has an engine cover which is not...