Search results

What condition is the cockpit door down to the living area? Does it fold up or slide to the right? If it folds up, let me know cost and send photis.

My electric choke is apparently bad. Mechanic claims new ones are unavailable. Anyone know where I can buy one for the Rochester 4 barrel, 1985 340 with 454's?

On a 1985 with 454's, what sensors send signals to the alarm? SB engine has normal cooling temp.and oil pressure, but alarm is ringing about 10 seconds after start up. Trans fluid level is fine.

Stock 454 engines, recent rebuild. SB engine will not run unless gas is poured into the carb , then will run fine and restart fine. Port engine has no problems. Any suggestions on troubleshooting?

In trying to diagnose my windlass I found 3 unconnected wires at the windlass (spade terminals), and no obvious place to connect to. I've attched a photo of the relay. I also have 2 white wires coming from the bow foot switch that ends at the relay. Can any sens me photos of their windlass...

Accidentally cut through my transducer cable- 6 wires with copper/aluminum sheathing. Do I just solder the wires together, or are there metal connectors that I can use?

I have 110 throughout my boat - just not at the meter, although I show 110 at the voltmeter. Maybe the gauge is broken?

When should the voltmeter register use? I've circled which one in the photo.

I need the cover plate for the vent switch in the head. Mines an 85 SDA, but I don't really care what it looks like. It screws onto the switch.

Still have the worn splitter? How much to 91360?

Thanks all. I've yet to try out the windless, so I'll check it out next week.

I've no use for the ladder and don't really want to store it. Price is very negotiable. Shoot me a reasonable price. Looks to be in very good shape. Includes blue storage bag.

On the bow of my 85 Sda there is a thing labeled plath. What is this for? I've circled.the thing in the photo.

My 85 SD, 454 engines, had the cutlass bearings and dripless bearings replaced 7 years ago, then sat in the water without being run. Boatyard says they need to be replaced due to age. Should they be replaced? Or, is there any way to determine if they need to be replaced?

My 85 340 SD, 454 engines, needs the dripless seals replaced. Yard said the engines have to be pulled. Is this true? Any alternatives to pulling the engines?

Where did you buy the rollers?

I provide a roll of doggie poo bags in the head for disposal of those items. Cheap and convenient.

I faced the same issue on my 85 340. I also removed all the screws, etc., and the device pulled out maybe an inch. I'm pretty certain it's the water/drain lines behind it. I haven't tried again as my boat is in drydock. There should be a white 1" PVC pipe that is the drain line, and I don't know...

Wow, you guys know a lot about engines. Maybe you can help me with a similar issue. I recently bought a 340 with 454 engines. The previous owner had installed rebuilt engines but had issues with them upon startup and put less than 30 minutes run time on them. The engines have not been run the...

I'm in Ventura - 34 ft 340 Sundancer