Search results

  1. Blacksslumina

    Removing the Engine: 1980 Sea Ray 245

    Hello all, I am pulling the motor out and have misplaced my Seloc manual, all electrical and control cables have been removed, I only have 3 bolts to unscrew then I can lift her out. Does anything else need to come off before i lift it out? The boat has a closed cooling system, with thru hull...
  2. Blacksslumina

    Fiber patching method

    Hello, need to repair hole in boat it’s about the diameter of my index finger 1/2 in or slightly bigger. Would marine Tex putty be the right type of application for this size patch or should I still use cloth and resin? Thx for your input
  3. Blacksslumina

    Need some guidance on a Points Distributor

    Hello I have a 80's Model Sundancer 245 and was in the process of trying to get it started after its been dormant for years. I had a mechanic come attempt to fire it up and upon his inspection he recommends new points and distributor cap. Furthermore he told me that I should just upgrade to a...
  4. Blacksslumina

    Can a stuck motor be turn from the prop?

    trying to turn a 305 motor that hasn't ran in years, the crank bolt was stripped by PO, and the starter just clicks when I turn the key, I jumped the starter solenoid and it sounded like it tried to move once but its not budging since then. If i put it in gear and try to turn the prop nut...
  5. Blacksslumina

    How should the bow roller sit?

    Im not sure if my trailer is set up properly for the boat but I just replaced the bow tow eye and would like to adjust it now if it's needed. It's a double bow roller, should it sit above the top roller or in between them? Thanks
  6. Blacksslumina

    Crankshaft bolt size- 1980 mercruiser 305 5.0L

    Found answer, pls delete
  7. Blacksslumina

    1980 Sea Ray SRV 245 Sundancer Coolant Routing

    Hello just bought this boat trying to make sure things are where they need to be before trying to start it up. Any info on why the plug is in the hose? How should it be ran?
  8. Blacksslumina

    New Member from Atlanta Area 1981 Sea Ray 245

    Hello im Lorenzo, just bought my first boat a 1981 Sea Ray 245, Its a fixer upper. Previous owner had limited info but I decided to roll the dice. I'm not into it for a whole lot so i'll just go with the flow on this one. Any input on how i can test to see if the motor and out-drive is...
Back
Top