Does anybody have an alternate solution to shrink wrap on the 390 dancer. I think the regulations are coming down the pike that will eliminate the use of shrink wrap. My town is in discussion now as it is not recyclable. Custom winter cover? I don't know if anybody makes them.
Does anybody have a good answer for water entering the boat engine compartment during rough seas?. I heard there are special baffles That reduces and seperatey water flow. The intakes are kind of low,and these cummins need a lot of air to breath. I also get water during heavy rain which is...
Has anybody added an extended swim platform? I'm interested in adding a lower tier to the platform, similar to the one on my 97 330 dancer. Just wondering if some company has a ready made bolt on design.
I'm the second owner of this 05 390 DA, my owners package is missing section 3, could anybody know what it is? I'm also looking for any info on the ice maker, brand? Model?
I have a 2005 390 DA w/o cockpit a/c. Where do you locate the unit and the duct work? Sounds like a nice option along with the camper back canvas like Tman had.
I have a question regarding losing an engine. I have cummins Qsb 380 with ZF transmissions, dripless shaft logs witch are water cooled. If I were to lose an engine and require a tow is there some procedure that must be followed. I am planning an early trip from the south shrore of LI to the...
Thanks again Tom, it was 17 degrees when I was down there and I didn't see any kind of opening, but I should find it now. If there's no door I'll be sure to add one.
Thanks
WAM
Hello again people,
I'm refinishing the inside wooden steps on my 2005 390DA. Top three steps are easy to remove, can somebody tell me how to remove the bottom step? Looks like it should be storage underneath but doesn't budge. Can't see any fasteners either.
Hello fellow Sundancers, I just bought my 2005 DA this summer. The previous owner experience a problem with the a/c water pump relay. He hot wired the pump to an extension cord so it needs to be plugged in to run the unit. I can't seem to find where the relay is located, I guess my predesessor...
Hello Tom,
My apologies I’m a new member getting his feet wet on this site. I will do some diligence and try to find out if these will work for my needs. Same boat you had so it’s probably good. Can you send pics? And any performances data you have. Wamilanese@yahoo.com
Regards
Bill