I have a 2004 Sea Ray 340 Sundancer With the engine and generator exhaust ports that are moulded/built into the hull with no actual thru hull fittings to remove. They are quite unsightly with chipped and damaged gel coat.
Inside the bilge is a long tube that runs from the hull to which the...
You are correct, and I was mistaken. The SR location is not exactly on the centre line, I looked again. It is standard location for the factory installed Raymarine/Smartcraft transducer.
The replacement is a through hull and I got it confirmed today that this area is relatively flat so does...
I am just replacing my original RL70C chartplotter/radar and Smartcraft, with SIMRAD EVO3 and VesselView.
I can't find any information on the factory fitted through hull transducer for the tilt angle.
The installer who is doing the work is removing the original transducer (forward centre line...
I know there have been a few threads on this subject already so apologies if I am covering old ground but I need some advice please.
Want to change out old white Windlass footswitches on 2004 Sea Ray 340 Sundancer fitted with Lofrans Progress Windlass to stainless steel.
Questions I have:
1...
Hi Kevin,
I concur with others on this thread. You don’t need to replace the fittings just change out the bulbs. I replaced all of mine in cabin including the bilge lights to LEDs, so much brighter. Also changed out all the cockpit lights to lights to Lumitec dual colour with built in bezel...
Hi this is my first post here having just taken ownership of a 2004 340 sundancer.
Please can someone tell me how I unlatch and pull out the sliding platform for the old CRT located in the galley. I didn't see anything obvious and it seems really stiff so I didn't want to break anything. I...