That is exactly what is transpiring. . It is the first time I have dewinterized on the hard with the muffs. It's time to find the water source before launch.
Thanks
This water accumulation is an ongoing issue for a couple of seasons. After every outing there is water in the bilge and I figure it's time to find the source. I have to access the clamps on all the water hose connections and tighten them up. The cool fuel module was changed out a few seasons...
Thanks for your information.
I did not remove a drain plug. The water accumulation mysteriously came from a another source which is what I am searching for. Where and how to find the infiltration is my issue. What do you suggest I do?
Thanks
Mercruiser 5.7 bilge water leak problem. Started the engine on the hard with muffs attached.
Let her run until 160 temperature achieved. Removed the drain plug and water drained for about 30 seconds. Obviously I have a problem. like a leaking hose, but where? As per the pic attached, I have 3...
Accomplished yesterday as per your photo.
I am now vertically standing in the ski locker. Super.
Do you have water in your bilge? I have about 1 inch sitting there.
Also getting ready for winterization. I am able to see 3 blue drain plugs. I believe there is 5 but I cannot find the other 2. I...
Read with interest that you can move the gas spring on the mid floor hatch in order for it to open at 90 degrees. Anyone accomplish this and if so how.
Thanks
Sorry for the late reply news.
The distributor housing was repaired with epoxy and reinstalled without a leak.
Being a cautious person, I purchased a new one and personally reinstalled it and now I have a spare. One thing I realized in the removal and install is to loosen the clamps and get the...
Thanks for this information.
My mechanic removed the water distribution housing and epoxied the cracked unit after grinding it in preparation. It will be installed today and will let you know the results.
310 is a great boat!!
Wrapped my outdrive in a plastic garbage bag for winter storage,
Removed it yesterday and found some gear oil inside the bag.
What tests should I perform to find the source of the leak?
Thanks for any information.
I connected filters to the shore water hose and then connected another small hose from the filters to the water inlet valve in the lazarette. I have an outlet valve in the lazarette to which I connected a hose which I use to fill my water tank. I now have filtered water in the tank which feeds...
Had the same surgery years ago. Fell down from the stairs on my 400DB bridge to cockpit. OUCH!!! Had 7 tears laparoscopy repaired. Sling for 6 weeks and physio therapy afterwards. Very important.
Good luck with yours and heal quick. Ready for next season.
Here's another ripoff establishment. Boathouse Marine Center in Pompano Beach promoted a Parts Manager to Service Manager who only knows how to gouge for large repair bills. They even charged time for an estimate.
Be aware or stay away.
I had an problem with my 2006 Sundeck bilge pump recently.
There is a pump and a float switch to check. They are reachable by removing the motor panel and reaching under the motor. Lift the float switch and see if the pump engages. The pump is removable to see if it is clogged. My problem after...
Looking to replace with same model.
That would be fantastic and yes I would pay for shipping.
Would you be so kind and send me a PM and I will provide you with my Canadian address.
If you mark the package as a gift, there would be no customs issues.
Waiting for your email.