I have a 2008 310 DA with DTS and twin 350 stern drives, Bravo IIIs. When I drop my starboard engine into gear it either barely moves or does so very slowly. I must increase the RPM slowly to get it to engage or get it to operate normally. Really noticeable when backing into the slip. The...
Anyone know what the generator error code "62 Err" means? I am getting this code on the remote start module at the main power panel in the salon. I can start it at the main panel on the gen itself, just not at the remote.
It's definitely not silicone between the arch and the hull. The material is dark gray and hard as cement. Yes, they do have the white silicone in the joint around the outside for cosmetics, but the inside stuff (I can see through access hole on inside of arch) is solid! Will definitely have a...
Anybody have experience or advice for removing the arch on a 310/330? I am wanting to install a hinge system so that I can lower to get under low bridge on my lake.
Has anyone ever removed an arch from a Sundancer? There are only 4 bolts on each side. However, it appears they applied is epoxy in the joint between the arch and the hull before bolting it down. How difficult would the arch be to remove. I'm aware of the wire/cable 'issues' just curious...
Thanks for all the advice. Too bad there's not a "Super Admiral" pill I could slip her. The boat gets pulled out for winter at the end of the month. That gives me all winter to try and bring her around!
All good comments guys. Definitely have a dilemma on my hands. I leave her every weekend at about 3:00 on Friday afternoon and return from the lake Sunday night. Good thing we work in the same office or I'd never see her. Yep, she's hot and a great gal. She did almost drown when she was...
OK, Just found out my girlfriend doesn't like boats and is terrified of being on the water or even around the dock. Any ideas on how to rectify this situation?:huh:
Lucky me, I just had to replace my impeller sat. Gen cut out after running for 2 minutes. Service code said "LOC" (low on coolant). Just happened to be getting gas at the dealers dock and asked if someone could look at it. Tech fist checked strainer and cleaned it out (wasn't even dirty)...