Search results

WANTED: My boat didn't have the "C" clamps that secure the original AC and tray to the wood planks in the forward berth compartment . Anyone have a source for these? TIA

I might have two starting issues going on here. Sometimes on startup and idle on the starboard engine it will show no oil pressure on the gauge and red light will be on steady on the systems monitor. Other attempts it will start and idle fine with good pressure on gauge and red light out...

Looking for tips on removal and replacement of a tachometer. Thanks!

First year of ownership. Looking for advice replacing my Starboard tach which has failed. Is it just a matter of taking the screws out of the instrument dash and pulling out the board to access the bracket? Anything else to consider while doing this job? Thanks!

I have 6.2L Mercruiser motors set up with bravo 3's. The starboard engine will not shift into reverse. It will operate the throttle normally but not engage the outdrive. At first, it would take about 1000-1500 RPM to engage reverse on the way back with the throttle and now nothing? Could this be...

Does anyone have a source for the original air conditioner's filter in this boat ( TaylorMade Cruisair 12000 BTU)? Made some inquires but no luck so far! Thanks.

I have been mostly lurking on the forum here with a few posts trying to educate myself before buying my first cruiser. After a year or so of searching I was able to find a boat here in Seattle close to home! The contract is signed now just going through the process with the Survey coming up. For...

For the Dancer 340 folks: I am looking at a 2000 340 that only has the factory canvas and not the full stand up enclosure with the isinglass. Any idea what I can expect to pay for this and would any of it marry up to the factory included canvas? Thanks for any help!

Greetings, I currently own a 1998 210 Bowrider and am about to jump in to a 2000 340 Sundancer. I'm up in Seattle and have found an available boat in Anacortes, Wa. so it sits in salt water. I plan to keep the boat in Lake Washington full time which is fresh water and use it in the Summers out...

Hi Gang, Looking at a 2000 Searay Sundancer 340. The engines were replaced in 2010. They are Merc 7.4 's with 980 hours on them. Any reason to eliminate this boat because of that? Future value, etc. TIA

I have a 1998 SR 210 Bow rider with a 5.0 Merc. I am trying to change out the dirty power steering fluid and have consulted the online manual for the engine. It only talks about how to add fluid to the fill line when the engine is hot or cold. I don't know what type of PS fluid the prior owner...

I normally hang out in the sport boat section of the forum since I own a 1998 210 Bowrider. Love the Sea Ray brand! I'm starting my search for a bigger boat!(of course) I live in the Seattle area and have narrowed the search to a Sundancer. It would be moored in a lake marina and used in Puget...

1998 210 Bow rider. Anyone know of a good way to remove some red dock paint that rubbed on the strip of blue boat paint just under the metal trim surround? Perhaps a good solvent that won't hurt the trim paint or orbital polisher? Thanks!

Guys, When I turn the ignition key there is no beep or clicking...Outdrive WILL raise and lower normally and engine will not crank. Throttle perfectly neutral. This is what has been tried so far... 1-no power to fuse panel after a test 2-5 fuses in engine area all test fine with meter 3-ran...

I had an incident at a dock over the weekend that did some gouging in my mid starboard wing railing. The stainless steel strip on the top is ok but a nail head sticking out of the dock dug into the plastic bowed railing underneath. I am getting the gel coat for some touch up but does anyone have...

New to Bowrider 210 last Fall and this is my first de Winterizing season. As it relates to the 5 blue wing nut water plugs on the engine and manifold: They screwed back in the plug holes easy enough. Lacking a little confidence I put them in the right places! They are sometimes tough to find...

Taking a poll as to what others have done in the way to adding a compass to their boat when it came without one. I have a 1998 Bowrider 210 I bought used last year. I dont want to do flush mount but it does have the compass platform on top of the dash preformed for drilling the hole. Are bracket...

Hello all! First post here and just purchased first boat . She is a 1998 Signature Bowrider 210 with a 5.0L Mercruiser. Live in the Seattle area. First question as well....To freeze protect the engine do I just need to pull the 4 petcocks off of the engine and 1 for the manifold? Any other tips...